User manual SAMSUNG SYNCMASTER 96P

[. . . ] SAMTRON 76BDF/76DF/78DF User's Manual 2 Site Map Automatic Manual User's Manual 3 Safety Instructions Warning / Caution Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Notational Conventions Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock User's Manual 4 Safety Instructions Power When not used for extended periods of time, set your PC to DPMS. If using a screen saver, set it to the active screen mode. If the size of your monitor is small, or if the same image is present for long periods of time, you may see afterimages due to damage to the flourescent substance on the inside of the CDT. q Do not use a damaged or loose plug. x This may cause an electric shock or fire. q Do not pull the plug out by the wire nor touch the plug with wet hands. x This may cause an electric shock or fire. q Use only a properly grounded plug and recepticle. x An improper ground may cause electric shock or equipment damage. q Do not excessively bend the plug and wire nor place heavy objects upon them, which could cause damage. x Failure to do so may cause an electric shock or fire. User's Manual 5 Safety Instructions q Disconnect the plug from the outlet during storms or lightening or if it is not used for a long period of time. x Failure to do so may cause an electric shock or fire. q Do not connect too many extension cords or plugs to an outlet. x This may cause a fire. User's Manual 6 Safety Instructions Installation q Do not cover the vents on the monitor cabinet. x Bad ventilation may cause a breakdown or fire. q Put your monitor in a location with low humidity and a minimum of dust. x An electric short or fire could result inside the monitor. q Do not drop the monitor when moving it. x This may cause damage to the product or human body. q Place the monitor on a flat and stable surface. x The monitor can cause injury by falling. q Set down the monitor carefully. x It could be damaged or broken. q Do not place the monitor face down on the screen. x The CRT surface may be damaged. q Do not use the monitor without the monitor stand. x It could break down or cause a fire due to bad ventilation. x If the monitor must be used without the supplied stand, take steps to insure proper ventilation. User's Manual 7 Safety Instructions Cleaning When cleaning the monitor case or the surface of the CRT, wipe with a slightly moistened, soft fabric. [. . . ] Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. 0. 7 Vpp positive at 75 ohms TTL level, positive or negative 30 ~ 85 kHz 50 ~ 160 Hz 12. 3 ± 0. 16 inch (312 ± 4 mm) 9. 2 ± 0. 16 inch (234 ± 4 mm) 17" (43cm) DynaFlat (40. 6cm viewable) 90° 0. 20mm (Horizontal) Silica coated with anti-electronic properties (TCO : Multilayer coating) Medium-short persistence phosphor. SAMTRON 76BDF User s Manual 34 Specifications General Specifications General Model Name Picture Tube Type Deflection angle Dot Pitch Screen type Maximum Resolution 1280 Dots, 1024 Lines Active Display Horizontal Vertical Synchronization Horizontal Vertical Input Signal, Terminated Analog Separate Sync Display Color Unlimited Maximum Pixel Clock 110 MHz Power Supply AC 100 ~ 240V ± 10%, 60Hz/50 Hz ± 3Hz Power Consumption 90W (Maximum), 75W (Nominal) Dimensions (WxDxH) 398 x 412 x 400 mm (with base) Weight 16. 2 kg Plug and Play Capability This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. 0. 7 Vpp positive at 75 ohms TTL level, positive or negative 30 ~ 70 kHz 50 ~ 160 Hz 12. 3 ± 0. 16 inch (312 ± 4 mm) 9. 2 ± 0. 16 inch (234 ± 4 mm) 17" (43cm) DynaFlat (40. 6cm viewable) 90° 0. 20mm (Horizontal) Silica coated with anti-electronic properties (TCO : Multilayer coating) Medium-short persistence phosphor. SAMTRON 76DF User s Manual 35 Specifications General Specifications General Model Name Picture Tube Type Deflection angle Dot Pitch Screen type Maximum Resolution 1280 Dots, 1024 Lines Active Display Horizontal Vertical Synchronization Horizontal Vertical Input Signal, Terminated Analog Separate Sync Display Color Unlimited Maximum Pixel Clock 110 MHz Power Supply AC 100 ~ 240V ± 10%, 60Hz/50 Hz ± 3Hz Power Consumption 90W (Maximum), 75W (Nominal) Dimensions (WxDxH) 398 x 412 x 400 mm (with base) Weight 16. 2 kg Plug and Play Capability This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. 0. 7 Vpp positive at 75 ohms TTL level, positive or negative 30 ~ 70 kHz 50 ~ 160 Hz 12. 3 ± 0. 16 inch (312 ± 4 mm) 9. 2 ± 0. 16 inch (234 ± 4 mm) 17" (43cm) DynaFlat (40. 6cm viewable) 90° 0. 20mm (Horizontal) Silica coated with anti-electronic properties (TCO : Multilayer coating) Medium-short persistence phosphor. SAMTRON 78DF User's Manual 36 Specifications Preset Timing Modes If the signal transferred from the computer is the same as the following Preset Timing Modes, the screen will be adjusted automatically. However, if the signal differs, the screen may go blank while the power LED is on. Refer to the video card manual and adjust the screen as follows. Model Name : SAMTRON 76BDF Display Mode Horizontal Frequency (kHz) IBM, 640 x 480 IBM, 720 x 400 VESA, 640 X 480 VESA, 800 X 600 VESA, 800 X 600 VESA, 1024 X 768 VESA, 1024 X 768 VESA, 1280 X 1024 31. 469 31. 469 43. 269 46. 875 53. 674 60. 023 68. 677 79. 976 Vertical Frequency (Hz) 59. 940 70. 087 85. 008 75. 000 85. 061 75. 029 84. 997 75. 025 Pixel Clock (MHz) 25. 175 28. 322 36. 000 49. 500 56. 250 78. 750 94. 500 135. 00 Sync Polarity (H/V) -/-/+ -/+/+ +/+ +/+ +/+ +/+ Model Name : SAMTRON 76DF/ 78DF Display Mode Horizontal Frequency (kHz) IBM, 640 x 480 IBM, 720 x 400 VESA, 640 X 480 VESA, 640 X 480 VESA, 800 X 600 VESA, 800 X 600 VESA, 1024 X 768 VESA, 1024 X 768 31. 469 31. 469 37. 500 43. 269 46. 875 53. 674 60. 023 68. 677 Vertical Frequency (Hz) 59. 940 70. 087 75. 000 85. 008 75. 000 85. 061 75. 029 84. 997 Pixel Clock (MHz) 25. 175 28. 322 31. 500 36. 000 49. 500 56. 250 78. 750 94. 500 Sync Polarity (H/V) -/-/+ -/-/+/+ +/+ +/+ +/+ Horizontal Frequency The time to scan one line connecting the right edge to the left edge of the screen horizontally is called Horizontal Cycle and the inverse number of the Horizontal Cycle is called Horizontal Frequency. Unit: kHz Vertical Frequency Like a fluorescent lamp, the screen has to repeat the same image many times per second to display an image to the user. The frequency of this repetition is called Vertical Frequency or Refresh Rate. Unit: Hz User's Manual 37 Specifications PowerSaver This monitor has a built-in power management system called PowerSaver. This system saves energy by switching your monitor into a low-power mode when it has not been used for a certain amount of time. The monitor automatically returns to normal operation when you move the computer's mouse or press a key on the keyboard. For energy conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for long periods. The PowerSaver system operates with a VESA DPMS compliant video card installed in your computer. Use a software utility installed on your computer to set up this feature. Model Name : SAMTRON 76BDF State Power Indicator Power Consumption Normal Operation Green 82W(Nominal) 100W(Maximum) Power-off Mode EPA/ENERGY 2000 Green, Blinking (1 sec. [. . . ] Cadmium damages the nervous system and is toxic in high doses. The relevant TCO'99 requirement states that batteries, the colour-generating layers of display screens and the electrical or electronics components must not contain any cadmium. Mercury** Mercury is sometimes found in batteries, relays and switches. It damages the nervous system and is toxic in high doses. [. . . ]