User manual SAMSUNG APH289SEF/XFO

[. . . ] OWNER'S INSTRUCTIONS APH289SEF APH289SEG Floor Stand type Air Conditioner (Cool and Heat) E R DB98-16484A(2) Register your product at www. samsung. com/global/register Safety Precautions The following safety precautions must be taken when using your air conditioner. · Disconnect all remote electric power supplies before servicing, installing or cleaning. · This must be done by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard. x Users of this product are cautioned not to attempt repair of this product at their own discretion. [. . . ] x The air conditioner cools or heats the room as quickly as possible. x After 30 minutes, the air conditioner is reset automatically to the previous mode, temperature and fan settings. But, if you press the button in DRY or FAN mode, it will change to AUTO mode automatically. 3 If you wish to stop the Turbo function before the end of the 30-minute period, press the Result: button again. The air conditioner is reset automatically to the previous mode, temperature and fan settings. 4 To select the Digital Flow, refer to page 16. 5 To control the direction of the air flow, refer to page 17. E-14 Selecting Health Mode If you wish to clean the air during cooling/heating operation, select the Health mode. In the Health mode, the perfect air cleaning is also operated and the optimum air flow direction is selected automatically. 1 If necessary, press the Result: (On/Off) button. x The operation indicator on the indoor unit lights up. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Switched on x Stopped lt will start up normally after three minutes. button. IMPORTANT 2 Select COOL or HEAT mode by pressing the Note You can select the Health mode only in COOL, HEAT or TURBO mode. x The air conditioner runs in the Health mode. x The perfect air cleaner opens and it provides clean air to the room. in TURBO mode, the TURBO operation is 3 Press the Result: Note 4 To adjust the temperature, press the button one or more times until the required temperature is displayed. Note Adjustable temperature x In COOL mode : 18°C ~ 30°C x In HEAT mode : 16°C ~ 30°C 5 To select the fan speed, press the the required setting is displayed. button one or more times until 6 To select the Digital Flow, refer to page 16. E-15 Selecting Digital Flow In Cool, Heat, Turbo or Health mode, you can adjust the Digital Flow depending on your needs. 1 Select COOL, HEAT, TURBO or HEALTH mode first. 2 Press the button once or more times as required. The air conditioner blows cool/hot air into a specific area. The air conditioner blows cool/hot air into wide/whole area. The air conditioner blows cool/hot air into distant area. The air conditioner blows cool/hot air into every corner. 3 To cancel the Digital Flow, press the indicators disappear. button until the Digital Flow Note x If you select the Digital Flow in Turbo or Health mode, it will change to Cool/Heat mode automatically. x If you press the or button, the Digital Flow is cancelled. E-16 Adjusting the Air Flow Direction Vertically Depending on the position of the indoor unit on the wall of your room, you can adjust the position of the outer air flow blade on the bottom of the unit, thus increasing the efficiency of the air conditioner. 1 Press the Result: button one or more times as required. The outer blades are adjusted vertically. Cooling Heating Adjust the blade to face. . . Downwards. RECOMMENDATION 2 If you want the blades to move up and down automatically when the air conditioner is operating, press the Result: button. The blades move up and down, around the base position set. 3 To stop the blades moving up and down, press the button again. Adjusting the Air Flow Direction Horizontally There are two sets of inner air flow blades. Just as the outer air flow blade can be adjusted vertically, the inner blades can be adjusted horizontally. 1 Press the Result: button one or more times as required. [. . . ] If the cooling operation is used at over 33°C(indoor temperature), it does not cool at its full capacity. E-25 Cleaning Your Air Conditioner For the best use of your air conditioner, you must clean it every two weeks regularly to remove the dust that accumulates on the air filter. IMPORTANT 1 Air inlet cover Before cleaning your air conditioner, ensure that you have switched off the breaker used for the unit. Open the air inlet cover, then pull out the air filters. 2 Remove all dust on the air filters with a vacuum cleaner or brush. 3 When you have finished, insert the air filters into the original position and close the air inlet cover. 4 Clean the unit with a damp cloth and mild detergent (do NOT use benzene, solvents or other chemicals). Note x If you have not used the air conditioner for a long period of time, set the fan going for three to four hours to dry the inside of the air conditioner thoroughly. E-26 To Clean the Filter You have to clean the filter once a month and cleaning cycle depends on the time that the air conditioner is used. 1 Open the front panel, then pull out the filter. 2 Clean the Note filter with tepid running water. x Do not disassemble the filter when you clean the filter. [. . . ]