User manual SAMSUNG APH523QF

[. . . ] OWNER'S INSTRUCTIONS APH503QG APH523QF APH553QF FLOOR STAND TYPE AIR CONDITIONER ( Cool and Heat ) E A DB98-19122A(2) Register your product at www. samsung. com/global/register Safety Precautions The following safety precautions must be taken when using your air conditioner. · Disconnect all remote electric power supplies before servicing, installing or cleaning. · This must be done by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard. x Users of this product are cautioned not to attempt repair of this product at their own discretion. [. . . ] You can change modes at any time. button on the button. 3 To adjust the temperature, press the buttons on the remote control or buttons on the control panel one or more times until the required temperature is displayed. Possible temperatures are between 16OC and 30OC inclusive. Result: x Each time you press the buttons: - The temperature is adjusted by 1OC. x The air conditioner starts heating, provided that the room temperature is lower than the selected temperature. x For the first 3~5 minutes, the fan may not operate to prevent the cool air from running out of the indoor unit. x If the room temperature reachs the set temperature, the air conditioner stops heating, but the fan is still operating. x The Defrost indicator( ) appears when frost forms on the outdoor unit and disappears automatically after removing frost. 4 Select the fan speed by pressing the button on the remote control or button one or more times until the required setting is displayed : Automatic(rotated : Low High Result: x Each time you press the button, the indoor unit beeps. ) 5 To control the direction of the air flow, refer to page 16. Note You can't control the airflow direction when the fan doesn't operate. E-10 Selecting the Automatic Operating Mode You can start the air conditioner in the Automatic mode. In the Automatic mode, the temperature and the optimum fan speed is selected automatically. 1 If necessary, press the Result: (On/Off) button. x The power indicator on the control panel comes on. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Switched on x Stopped lt will start up normally after three minutes. IMPORTANT 2 If the is not displayed on the control panel, press the remote control one or more times until it appears. Result: Note x The indoor unit beeps each time you press the x The air conditioner runs in the Auto mode. x The indoor unit beeps. IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Switched on x Stopped lt will start up normally after three minutes. 2 Press the Result: button twice. x The air conditioner cools the room as far as possible. x The fan settings are adjusted automatically. 3 To adjust the temperature, press the buttons one or more times until the required temperature is displayed. Possible temperatures are between 18OC and 30OC inclusive. Result: x Each time you press the buttons: - The temperature is adjusted by 1OC. - The indoor unit beeps. 4 If you wish to stop the Long function, press the Result: button again. x The air conditioner is reset automatically to the previous mode, temperature and fan settings. 5 To control the direction of the air flow vertically, refer to page 16. Note You can't control the airflow direction horizontally in the Long function. E-13 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. 1 If necessary, press the Result: (On/Off) button. x The power indicator on the control panel comes on. x The indoor unit beeps. IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Switched on x Stopped lt will start up normally after three minutes. 2 If the is not displayed on the control panel, press the remote control one or more times until it appears. Result: Note x The indoor unit beeps each time you press the x The air conditioner runs in the Dry mode. You can change modes at any time. button on the button. 3 To adjust the temperature, press the buttons one or more times until the required temperature is displayed. [. . . ] The automatic protection feature may be triggered and the air conditioner stopped. A water leakage or some other malfunction may happen if the heat exchanger freezes. Water may condense on and drip from the surface of the indoor unit if it is used for a long periods. Low temperature High humidity levels Mode Heating Cooling Drying Outdoor Temperature 0°C to 24°C approx. 18°C to 54°C approx. Indoor Temperature 27°C or less. [. . . ]