User manual SAMSUNG ASK12G6VE

[. . . ] OWNER'S INSTRUCTIONS Indoor Unit ASK09G6VE ASK12G6VE Outdoor Unit USK09G6VE USK12G6VE Split-type Room Air Conditioner (Cool) E S DB98-24286A(1) Register your product at www. samsung. com/global/register Safety Precautions You should take the following safety precautions when using your air conditioner. · If you don't follow the safety precautions, you may get the risk of an electric shock, injury or death. ·The manufacturer or qualified service personnel must install this air conditioner. · Unplug the electric power before repairing, installing or cleaning. WARNING DURING OPERATION x Do not repair the air conditioner at your discretion. It is recommended to contact a service center directly. [. . . ] Result: x The indoor unit beeps each time you press the MODE button. x The air conditioner runs in COOL mode. You can change modes at any time. Note 3 To adjust the temperature, press the TEMPERATURE buttons one or more times until the required temperature is displayed. Possible temperatures are between 18°C and 30°C inclusive. Result: x Each time you press the TEMPERATURE buttons: - The temperature is adjusted by 1°C - The indoor unit beeps x The air conditioner starts cooling, provided that the room temperature is higher than the selected temperature; the fan will, however, operate. 4 Select the fan speed by pressing the FAN button one or more times until the required setting is displayed: Automatic (rotated : Low Medium High Result: Each time you press the FAN button, the indoor unit beeps. ) 5 To control the direction of the air flow, refer to page 15. E-11 Changing the Room Temperature Quickly The Turbo cooling function is used to cool your room as quickly as possible. Example : You have just come home and find that the room is very hot. You wish to cool it down as quickly as possible. The Turbo function operates for 30 minutes with the maximum settings before returning automatically to the mode and temperature previously selected. 1 If necessary, press the Result: (On/Off) button. x The 5 Way indicator on the indoor unit lights up. x The air conditioner starts up in the mode selected when the unit was last used. x The indoor unit beeps. 2 Press the Result: button. x The temperature and fan settings are adjusted automatically. x The air conditioner cools the room as quickly as possible. x After 30 minutes, the air conditioner is reset automatically to the previous mode, temperature and fan settings. But, if you press the button in DRY or FAN mode, it will change to AUTO mode automatically. 3 If you wish to stop the Turbo function before the end of the 30-minute period, press the button one or more times until or disappears. Result: The air conditioner is reset automatically to the previous mode, temperature and fan settings. 4 To control the direction of the air flow, refer to page 15. E-12 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. 1 If necessary, press the Result: (On/Off) button. x The 5 Way indicator on the indoor unit lights up. x The air conditioner starts up in the mode selected when the unit was last used. Result: The outer blade is adjusted vertically. Upwards. RECOMMENDATION 2 If you want the blade to move up and down automatically when the air conditioner is operating, press the SWING button. Result: The blade move up and down, around the base position set. 3 To stop the blade moving up and down, press the SWING button again. Set to the initial position powered. Note Adjusting the Air Flow Direction Horizontally There are two sets of inner air flow blades. [. . . ] IMPORTANT 1 Before cleaning your air conditioner, ensure that you have switched off the breaker used for the unit. Open the front grille by pulling on the tabs on the lower right and left sides of the indoor unit. The removal of the front grille facilitates your cleaning of the air conditioner. After opening the front grille, lift up to the max, and pull to release them and vice versa. Lift out the bottom edge of the air filters and pull down to release them. [. . . ]