User manual SAMSUNG AV-MDH052CA0

[. . . ] x Provide occasional ventilation during use. x Do not direct air flow at fireplaces or heating apparatus. x Do not climb on, or place objects on, the air conditioner. [. . . ] However, be careful when you wash the surface of the heat exchanger because it is very sharp. E-5 ENGLISH Wireless Remote Controller-Buttons and Display The wireless remote controller is an optional accessory. To use the wireless remote controller, refer to an appropriate manual. Operating mode Temperature setting Mode selection button Temperature adjustment buttons Filter Reset button Fan speed Air flow direction On Timer setting Off Timer setting Battery discharge indicator Fan speed adjustment button Swing button (Not operated) On Timer button Off Timer button On/Off & Timer Set/Cancel button Note - After cleaning the air filter, press the filter reset button. - Duct type air conditioner does not have function of adjusting air flow direction. Therefore, the function is not operated even if you press the swing button. - The heating mode( ) is not selected in cooling only models. E-6 The Receiver & Display Unit ENGLISH E-7 The Receiver & Display unit is an optional accessory and it is installed on the wall. To use the receiver & display unit, refer to an appropriate manual. Concealed Type Filter sign indicator Fan indicator Timer indicator Remote control sensor - Heat Pump Models : On/Off indicator(Blue) & Removing frost indicator(Red) - Cooling Only Models : On/Off indicator Standard Type Removing frost indicator (Except Cooling Only Models) Filter sign indicator Remote control sensor On/Off indicator Fan indicator On/Off button Timer indicator Wired Remote Controller-Buttons and Display The wired remote controller is an optional accessory and it is installed on the wall. To use the wired remote controller, refer to an appropriate manual. Operating mode Removing frost indicator (Except Cooling Only Models) Centralized controller indicator (In case of installing the Centralized controller) Communication error indicator On Timer setting Off Timer setting Test indicator Temperature adjustment buttons On Timer button Off Timer button Test button Temperature setting Fan speed Air flow direction Filter Sign indicator On/Off & Timer Set/Cancel button On/Off indicator Fan speed adjustment button Swing button (Not operated) Filter Reset button Mode selection button Note - Test button is for your installation specialist. - After cleaning the air filter, press the filter reset button. Then the wired remote controller will display the FILTER SIGN indicator when the time to clean the air filter; refer to page 12 or 13. - Duct type air conditioner does not have function of adjusting air flow direction. Therefore, the function is not operated even if you press the swing button. - The heating mode( ) is not selected in cooling only models. E-8 Centralized Controller ENGLISH Operating lamp All On button All Off button On/Off indicators On/Off buttons Index E-9 The centralized controller is an optional accessory and it is installed on the wall. To use the centralized controller, refer to an appropriate manual. Note Operating lamp comes on when at least one air conditioner connected to the centralized controller is operating. Operating Recommendations Here are a few recommendations that you should follow when operating your air conditioner. Topic Heating performances Recommendation The heat pump function of the air conditioner absorbs heat from outside air and brings it indoors. As the temperature of the outside air drops, the heating performance of air conditioner will decrease. If you find that the room is not warm enough, using an additional heating appliance is recommended. [. . . ] operate at all Wired Remote Controller The air conditioner does not x is displayed on the wired remote controller. In this case, operate with the remote turn the air conditioner off and contact your dealer. controller Wired Remote Controller When turning on/off the air conditioner, it is not turned on/off immediately. [. . . ]