User manual SAMSUNG AW05N0AA

[. . . ] Make sure that the unit is correctly ventilated at all times: Do not place clothing or other materials over it. If the wireless remote control will not be used for a long time, remove the batteries. (If applicable) The air conditioner must be plugged into its own specific power source, which must be installed in compliance with national wiring, earthing and safety regulations. If the power cord is damaged in any way, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. [. . . ] Your Owner's Instructions contain much valuable information on using your air conditioner. Please take the time to read them as they will help you take full advantage of the unit's features. The illustrations in the step-by-step procedures use four different symbols: PRESS PUSH IMPORTANT NOTE E-5 Cooling Your Room You must select the Cool mode if you wish to adjust the: Cooling temperature Fan speed when Cooling 1 To switch the unit on, simply press the Power Control selector to the "On" position. Result: The air conditioner starts operating. 2 Turn the Thermostat dial and set it to " 1 ~ 10 ". Possible temperatures: Can be set between 18 °C and 29°C . Result: The air conditioner starts cooling if the room temperature is higher than the selected temperature. 3 Press the "Fan Mode" selector to the High or Low position. Result: The Fan speed is adjusted. 4 To control the direction of the air flow, refer to page 7. Ventilating Your Room 1 To switch the unit on, simply press the Power Control selector to the "On" position. Result: The air conditioner starts operating. 2 Turn the Thermostat dial and set it to "Fan only" position. Result: The air conditioner starts up in fan mode. 3 Press the "Fan Mode" selector to the High or Low position. Result: The Fan speed is adjusted. 4 To control the direction of the air flow, refer to page 7. E-6 Switching the Air Conditioner Off You can switch the air conditioner off whenever you want. To switch the unit off, simply press the Power Control selector to the "Off" position. Adjusting the Air Flow Direction Horizontally Depending on the position of the unit in your room, you can adjust the orientation of the inner air flow blades on the unit. Adjust the air flow blades to the desired position by pushing them side to side. E-7 Power Failure If a power failure occurs, the air conditioner is switched off. When the power comes back on, the air conditioner will start up automatically. Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges that the air conditioner can be used at. Mode Cooling Indoor Temperature 21°C to 32°C approx. The automatic protection feature may be triggered and the air conditioner will stop. A water leakage or some other malfunction may happen if the heat exchanger freezes. Water may condense on and drip from the surface of the unit if it is used for long periods. Outdoor Temperature 21°C to 43°C approx. Indoor Humidity 80% or less If the air conditioner is used at. . . Higher temperatures Lower temperatures Higher humidity levels E-8 Cleaning Your Air Conditioner Be sure to clean the air filter periodically to keep the air conditioner operating at optimum level. When cleaning the air conditioner, turn it off and pull out the power plug. 1 Open the front grille by pulling the tabs on both sides of the grille. [. . . ] - Refer to the specifications on the label attached to the unit. Installation Conditions 1 As the unit is heavy, the wall or window of the installation area should have sufficient strength and durability for operation of the air conditioner, and for prevention of any vibration or noise. If it is weak, reinforcement work should be performed separately. 2 It is advisable to install the air conditioner in the north or west side to prevent the effect of direct sunlight. [. . . ]