User manual SAMSUNG AW0801B

[. . . ] OWNER'S INSTRUCTIONS AW0801B AW1001B AW1201B AW1801B Window-type Room Air Conditioner (Cool) E S DB98-08496A(1) Safety Precautions The following safety precautions must be taken when installing and using your air conditioner. 1 The air conditioner must be plugged into its own specific power source, which must be installed in compliance with national wiring, earthing and safety regulations. Depending on national regulations and your specific installation, you may need to install: x A circuit breaker For further information on electrical requirements, contact a professional electrician. This device must be installed according to the national electrical rules. 2 Make sure that the unit is correctly ventilated at all times; do NOT place clothing or other materials over it. 3 NEVER spill liquids of any kind into the unit. Should this happen, unplug the unit and contact your installation specialist. 4 Do NOT insert anything between the air outlet blades, as it may damage the inner fan and you may be hurt. [. . . ] x When the air conditioner is in the Fan mode, the temperature cannot be set or displayed. 4 To set the fan speed: x Press the , or button on the remote control as desired. or x Press the button on the unit one or more times until the desired fan speed(F1, F2 or F3) is displayed. Low Medium High 5 To control the direction of the air flow, refer to page 11. E-9 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. You can operate the Dry mode only by using the control panel. Remote Control Control Panel 1 If necessary, press the Result: (On/Off) button. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after three minutes. 2 If the dry indicator is not displayed at the top of the control panel, press the button on the control panel one or more times until it appears. Result: x The unit beeps each time you press the x The air conditioner runs in Dry mode. button. 3 or buttons one or To adjust the temperature, press the more times until the required temperature is displayed. Possible temperatures are between 64°F and 86°F inclusive. Result: x Each time you press the or buttons: - The temperature is adjusted by 1°F - The unit beeps x The air conditioner starts removing the excess humidity; the quantity of air is adjusted automatically. 4 To control the direction of the air flow, refer to page 11. E-10 Adjusting the Air Flow Direction Horizontally Depending on the position of the unit in your room, you can adjust the orientation of the inner air flow blades on the unit. 1 Adjust the air flow blades to the desired position by pushing them side to side. Adjusting the Air Flow Direction Vertically Again depending on the position of the unit in your room, you can adjust the orientation of the outer air flow blades on the right-hand side of the unit. Upwards. 1 Adjust the air flow blades to the desired position, by pushing them upwards or downwards. If you orient the air flow blades downwards and the unit operates in Cool mode for long periods of time, dew may: x Form on the surface of the blades x Drip from the blades E-11 Setting the On Timer The On Timer enables you to switch on the air conditioner automatically after a given time. You can select the On timer only when the air conditioner is off. You can select the On timer only when the air conditioner operates in the Cool mode. Remote Control Control Panel 1 Check that the air conditioner has been switched off; if necessary, press the (On/Off) button. 2 Set the operating time by pressing the button on the remote control one or more times until the desired time is displayed. The operating time can be set between 1 and 24 hours. Result: x Each time you press the button: ­ The time is adjusted by 1 hour and displayed on the control panel ­ The unit beeps x The operating time is displayed and decreases automatically to indicate the remaining time. x The "SLEEP" passes through the control panel for about 15 seconds and the " " will be displayed. x The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. x The air conditioner will be controlled as illustration below. Cooling When the temperature has been increased by 2°F (after 1 hour), it is maintained for 7 hours. To Cancel the Sleep Timer To cancel the timer, press: x The button on the remote control. x The SLEEP indicator is no longer displayed. x The air conditioner operates in the mode selected last. [. . . ] Model AW0801B AW1001B AW1201B AW1801B Power Supply 115V~, 60Hz 230-208V~, 60Hz E-19 SAMSUNG ROOM AIR CONDITIONER LIMITED WARRANTY TO ORIGINAL PURCHASER This SAMSUNG brand product, as supplied and distributed by SAMSUNG ELECTRONICS AMERICA, INC. (SAMSUNG) and delivered new, in the original carton to the original consumer purchaser, is warranted by SAMSUNG against manufacturing defects in materials and workmanship for a limited warranty period of: One (1) Year Parts and Labor, Five (5) Years Parts Warranty for Compressor This limited warranty begins on the original date of purchase, and is valid only on products purchased and used in the United States. Warranty repairs must be performed by SAMSUNG's authorized service center. To receive warranty service, the original dated bill of sale must be presented upon request as proof of purchase to SAMSUNG or SAMSUNG's authorized service center. [. . . ]