User manual SAMSUNG AW08NHAB

[. . . ] Getting Started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Inserting the Remote Control Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 4 5 6 7 OPERATING YOUR AIR CONDITIONER Cooling Your Room . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] - on the battery with - on the remote control. Close the cover by sliding it back until it clicks into place. 2 3 E-7 You must select the Cool mode if you wish to lower the temperature in your room. You can also set the Fan speed. Remote Control Control Panel It will begin to cool after three minutes is displayed. 18 C 30 C C I higher than the selected temperature, the air conditioner starts cooling Airing Your Room If you want to provide air circulation without cooling, you can use the Fan mode. 1 If you wish to evacuate stale air outside, push the ventilation lever on the ). front of the unit to the right and the open position ( Result: The air inside the room circulates and stale air is evacuated outside. Otherwise, push the ventilation lever to the left and the closed position ( Result: ). The air simply circulates inside the room . 2 If necessary, press the Result: (On/Off) button. Remote Control Control Panel The Air Conditioner starts up in Cool mode. The unit beeps twice. 3 If the Fan Speed(F1, F2 or F3) is not displayed on the control panel: Press the button on the remote control or Press the button on the unit one or more times until the Fan Speed (F1, F2 or F3) is displayed. The unit beeps each time you press the / button. Result: The Air Conditioner starts up in Fan mode. Cool/Dry/Fan Mode Cool/Dry/Fan Mode You can change modes at any time. When the Air Conditioner is in Fan mode, the temperature cannot be set or displayed. 4 To set the Fan Speed: Press the , or button on the Remote control as desired. or Press the button on the unit one or more times until the desired Fan Speed(F1, F2 or F3) is displayed. Fan Speed 5 To control the direction of the air flow, refer to page 11. E-9 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. Remote Control Control Panel 1 If necessary, press the Result: (On/Off) button. The air conditioner starts up in the Cool mode. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will begin to cool after three minutes. 2 If the temperature is not displayed on the control panel: Press the button on the remote control or Press the button on the unit one or more times until Result: The unit beeps each time you press the / The air conditioner starts up in the Cool mode. You can change modes at any time. is displayed. [. . . ] 3 When installing the air conditioner, be sure to obtain sufficient space on the rear side of the unit for smooth flow of air. When operating the air conditioner in closed areas such as inner building with cooling operation, and result in trouble with the unit. See the illustration below. Awning 300mm 65mm min. 500mm 500mm 145mm 500mm Approx. 3° 750mm 110mm min. If the wall is greater than 110mm thick, cut the wall back on a 45 angle if possible. [. . . ]