User manual SAMSUNG AW09LFAEA

[. . . ] Window-type Room Air Conditioner ( Cool ) Acondicionador de aire doméstico sistema de tipo ventana ( Refrigeración ) Climatiseur de type Fenêtre ( Refroidissement ) O ar Condicionado de Window-Type ( Refrigeração ) Condizionatore d'aria per ambienti da finestra ( Raffreddamento ) E S F P I DB98-08244A(3) ITALIANO PORTUGUÊS FRANÇAIS AW07LFABA/DA/EA AW09LFABA/DA/EA AW10LFABA AW12LFABA/DA/EA ESPAÑOL OWNER'S INSTRUCTIONS MANUAL DE INSTRUCCIONES MANUEL D'UTILISATION MANUAL DE INSTRUÇÕES ISTRUZIONI PER L'USO ENGLISH Safety Precautions The following safety precautions must be taken when installing and using your air conditioner. 1 The air conditioner must be plugged into its own specific power source, which must be installed in compliance with national wiring, earthing and safety regulations. Depending on national regulations and your specific installation, you may need to install: A circuit breaker For further information on electrical requirements, contact a professional electrician. This device must be installed according to the national electrical rules. 2 Make sure that the unit is correctly ventilated at all times; do NOT place clothing or other materials over it. 3 NEVER spill liquids of any kind into the unit. Should this happen, unplug the unit and contact your installation specialist. 4 Do NOT insert anything between the air outlet blades, as it may damage the inner fan and you may be hurt. [. . . ] button on the unit until F2 button on the remote control. button on the unit until F1 Med Low Result: Each time you press a button, the unit beeps. 4 To control the direction of the air flow, refer to page 10~11. E-9 Adjusting the Air Flow Direction Horizontally Remote Control Depending on the position of the unit in your room, you can adjust the outer air flow blades into the direction you want. 1 Press the Result: button on the remote control. Air flow blades swing automatically left and right. 2 To stop the blades moving left and right, press the on the remote control. button To stop the blades in a specific position and orient the air flow button in the corresponding direction, simply press the on the remote control when the blades are in the desired position. CAUTION Don't move the blades from the direction you operate with the remote control. If you force it inwards, the cool air doesn't flow into the room, but into the air conditioner. It may cause the malfunction. The proper range operated by the remote control Don't push the blades inwards When operating a swing button, if you move the blades, both blades operate separately. You can set the period of time from 1 hour to 24 hours. You can select the Off timer only when the air conditioner is on. Remote Control Control Panel 1 Check that the air conditioner has been switched on; if necessary, press the (On/Off) button. 2 Set the operating time by pressing: The button on the remote control or The button on the unit one or more times. Possible times are between 1 hour and 24 hour inclusive. Result: The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. The air conditioner switches off automatically when the operating time reaches zero. You can select the fan speed, direction of airflow and Energy saving mode after setting the On timer and Off timer mode. However, when you change the mode, the On timer and Off timer is canceled. You can set the On timer and Off timer mode only in the Cool mode. To Cancel the Off Timer To cancel the timer, press: Timer on the remote control or unit one or more times until " " is displayed. or The (On/Off)button on the remote control or unit to turn the air conditioner off and then turn it on again. (The air conditioner operates in the mode selected when the unit was last used. ) E-13 Setting the Sleep timer The Sleep Timer can be used when you are cooling your room to switch the air conditioner off automatically after a period of 8 hours. Remote Control Control Panel 1 2 If you wish to switch the unit off at a specific time, refer to page 13. Make sure that you have selected the COOL mode. Press the button on the remote control Each time you press a button, the unit beeps. The "SLEEP" passes through the control panel for about 15 seconds and the " " will be displayed. The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. The air conditioner will be controlled as illustration below. Result: Cooling When the temperature has been increased by 1°C (after 1 hour), it is maintained for 7 hours. To Cancel the Sleep Timer To cancel the timer, press: The button on the remote control. The SLEEP indicator is no longer displayed. The air conditioner operates in the mode selected last. [. . . ] Aluminum house wiring may pose special problems consult a qualified electrician. This unit requires a separate circuit, serving only this appliance. E-19 Installation Before installation, be sure to check the installation area or the air conditioner, and drain hose. Checkpoints prior to installation 1 Check the cabinet and front grille of the unit for any harmful defects such as scratches. 2 Be sure to check the power supply. - Refer to the specifications on the label attached to the unit. Installation Conditions 1 As the unit is heavy, the wall or window of the installation area should have sufficient strength and durability for operation of the air conditioner, and for prevention of any vibration or noise. [. . . ]