User manual SAMSUNG AW1291L

[. . . ] OWNER'S INSTRUCTIONS AW0691L AW0891L AW1091L AW1291L AW1891L Window-type Room Air Conditioner (Cool) E F DB98-09672A(1) Safety Precautions The following safety precautions must be taken when installing and using your air conditioner. 1 The air conditioner must be plugged into its own specific power source, which must be installed in compliance with national wiring, earthing and safety regulations. Depending on national regulations and your specific installation, you may need to install: x A circuit breaker For further information on electrical requirements, contact a professional electrician. This device must be installed according to the national electrical rules. 2 Make sure that the unit is correctly ventilated at all times; do NOT place clothing or other materials over it. 3 NEVER spill liquids of any kind into the unit. Should this happen, unplug the unit and contact your installation specialist. 4 Do NOT insert anything between the air outlet blades, as it may damage the inner fan and you may be hurt. [. . . ] Possible temperatures are between 18°C and 30°C inclusive. Result: x Each time you press the or buttons: - The temperature is adjusted by 1°C - The unit beeps x The air conditioner starts removing the excess humidity; the quantity of air is adjusted automatically. 4 To control the direction of the air flow, refer to page 20. E-11 Using the W i re l e s s Remote C o n t ro l This chapter indicates how to operate and program your air conditioner with the wireless remote control. E-12 Cooling Your Room You must select the Cool mode if you wish to adjust the: x Cooling temperature x Fan speed when cooling 1 If necessary, press the Result: (On/Off) button. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped lt will start up normally after three minutes. 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: x The unit beeps each time you press the x The air conditioner runs in the Cool mode. button. 3 To adjust the temperature, press the buttons one or more times until the required temperature is displayed. Possible temperatures are between 18°C and 30°C inclusive. is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. x The unit beeps each time you press the x The air conditioner runs in the Dry mode. button. 2 If the Result: 3 To adjust the temperature, press the buttons one or more times until the required temperature is displayed. Possible temperatures are between 18°C and 30°C inclusive. Result: x Each time you press the buttons: - The temperature is adjusted by 1°C - The unit beeps x The air conditioner starts removing the excess humidity; the quantity of air is adjusted automatically. 4 To control the direction of the air flow, refer to page 20. E-15 Setting the On Timer Remote Control The On Timer enables you to switch on the air conditioner automatically after a given time. You can select the On timer only when the air conditioner is off. You can select the On timer only when the air conditioner operates in the Cool mode. 1 Check that the air conditioner has been switched off; if necessary, press the (On/Off) button. 2 To set the operating time, press the button one or more times until the required time is displayed. Possible time is between 1 hour and 24 hours inclusive. 3 Press the Result: (Set/Cancel) button to complete the setting. x The remaining time is displayed on the remote control and the control panel. x Blinking of the timer indicator on the remote control stops. x The timer indicator lights up on the control panel. x The unit beeps x The air conditioner will switch on automatically in the cool mode when the counter displayed on the remote control and the control panel reaches the set time. You can select the temperature and Energy saving mode after setting the On timer mode. Control Panel To Cancel the On Timer 1 Press the (Set/Cancel) button. If you want to turn on the air conditioner before the timer reaches the setting time, press the (On/Off) button. E-16 Setting the Off Timer The Off Timer enables you to switch off the air conditioner automatically after a given time. You can select the Off timer only when the air conditioner is on. [. . . ] They may save you the time and expense of an unnecessary call. Problem The air conditioner does not operate at all Explanation / Solution x Check that the circuit breaker used for the air conditioner has not been triggered. x Check that the power cable is plugged into a wall socket and the socket is switched on, if necessary. x Check that the temperature indicator on the unit is lit; if necessary, press the (On/Off) button on the remote control or unit. x Check that there are no obstacles between you and the unit. [. . . ]