User manual SAMSUNG AW2400B

[. . . ] OWNER'S INSTRUCTIONS AW2400B Window-type Room Air Conditioner (Cool) E S DB98-08498A(1) Safety Precautions The following safety precautions must be taken when installing and using your air conditioner. 1 The air conditioner must be plugged into its own specific power source, which must be installed in compliance with national wiring, earthing and safety regulations. Depending on national regulations and your specific installation, you may need to install: x A circuit breaker For further information on electrical requirements, contact a professional electrician. This device must be installed according to the national electrical rules. 2 Make sure that the unit is correctly ventilated at all times; do NOT place clothing or other materials over it. 3 NEVER spill liquids of any kind into the unit. Should this happen, unplug the unit and contact your installation specialist. 4 Do NOT insert anything between the air outlet blades, as it may damage the inner fan and you may be hurt. [. . . ] or x Press the button on the unit one or more times until the desired fan speed(F1, F2 or F3) is displayed. Low Medium High 5 To control the direction of the air flow, refer to page 11. E-9 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. You can operate the Dry mode only by using the control panel. Remote Control Control Panel 1 If necessary, press the Result: (On/Off) button. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after three minutes. " indicator is not displayed at the top of the control panel, button on the control panel one or more times until it x The unit beeps each time you press the x The air conditioner runs in Dry mode. The " " passes through the control panel. button. 2 If the " press the appears. Result: 3 To adjust the temperature, press the or buttons one or more times until the required temperature is displayed. Possible temperatures are between 64°F and 86°F inclusive. Result: x Each time you press the or buttons: - The temperature is adjusted by 1°F - The unit beeps x The air conditioner starts removing the excess humidity; the quantity of air is adjusted automatically. 4 To control the direction of the air flow, refer to page 11. E-10 Adjusting the Air Flow Direction Horizontally Depending on the position of the unit in your room, you can adjust the orientation of the inner air flow blades on the right-hand side of the unit, thus increasing the efficiency of the air conditioner. 1 Press the Swing button on the remote control or unit. Result: The inner blades swing automatically left and right. Remote Control Control Panel In the Energy Saving mode, the blades may stop when the compressor is off. For details on the Energy Saving mode, refer to page 15. 2 To stop the blades moving left and right, press the Swing button again. To stop the blades in a specific position and orient the air flow in the corresponding direction, simply press the Swing button when the blades are in the desired position. Adjusting the Air Flow Direction Vertically The outer air flow blades can be adjusted to control the vertical air flow direction. Upwards. Adjust the air flow blades to the desired position, by pushing them upwards or downwards. If you orient the air flow blades downwards and the unit operates in the Cool mode for long periods of time, dew may: x Form on the surface of the blades x Drip from the blades E-11 Setting the On Timer The On Timer enables you to switch on the air conditioner automatically after a given time. You can select the On timer only when the air conditioner is off. However, when you change the mode, the On timer and Off timer mode is canceled. To Cancel the Off Timer To cancel the timer, press: x Timer on the remote control or unit one or more times until "--" is displayed. or x The (On/Off) button on the remote control or unit. E-13 Setting the Sleep Timer The Sleep Timer can be used when you are cooling your room to switch the air conditioner off automatically after 8 hours. Remote Control Control Panel 1 If you wish to switch the unit off at a specific time, refer to page 13. Make sure that you have selected the Cool mode. 2 Press the or Press the Result: button on the remote control button on the unit. x Each time you press a button, the unit beeps. x The "SLEEP" passes through the control panel for about 15 seconds and the " " will be displayed. x The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. x The air conditioner will be controlled as illustration below. Cooling When the temperature has been increased by 2°F (after 1 hour), it is maintained for 7 hours. To Cancel the Sleep Timer To cancel the timer, press: x Sleep on the remote control. x The SLEEP indicator is no longer displayed. [. . . ] Model AW2400B Power Supply 230-208V~, 60Hz E-19 SAMSUNG ROOM AIR CONDITIONER LIMITED WARRANTY TO ORIGINAL PURCHASER This SAMSUNG brand product, as supplied and distributed by SAMSUNG ELECTRONICS AMERICA, INC. (SAMSUNG) and delivered new, in the original carton to the original consumer purchaser, is warranted by SAMSUNG against manufacturing defects in materials and workmanship for a limited warranty period of: One (1) Year Parts and Labor, Five (5) Years Parts Warranty for Compressor This limited warranty begins on the original date of purchase, and is valid only on products purchased and used in the United States. Warranty repairs must be performed by SAMSUNG's authorized service center. To receive warranty service, the original dated bill of sale must be presented upon request as proof of purchase to SAMSUNG or SAMSUNG's authorized service center. [. . . ]