User manual SAMSUNG AW2490L

[. . . ] OWNER'S INSTRUCTIONS AW2490L Window-type Room Air Conditioner (Cool) E S DB98-08499A(1) Safety Precautions The following safety precautions must be taken when installing and using your air conditioner. 1 The air conditioner must be plugged into its own specific power source, which must be installed in compliance with national wiring, earthing and safety regulations. Depending on national regulations and your specific installation, you may need to install: x A circuit breaker For further information on electrical requirements, contact a professional electrician. This device must be installed according to the national electrical rules. 2 Make sure that the unit is correctly ventilated at all times; do NOT place clothing or other materials over it. 3 NEVER spill liquids of any kind into the unit. Should this happen, unplug the unit and contact your installation specialist. 4 Do NOT insert anything between the air outlet blades, as it may damage the inner fan and you may be hurt. [. . . ] x The air conditioner operates in the mode selected last. If you select the Energy Saving mode in the Sleep Timer mode, the Sleep Timer will be cancelled and the air conditioner will start up in the Energy Saving mode. E-14 Selecting Energy Saving Mode If you wish to save energy when using your air conditioner, select the energy saving mode. 1 To select the energy saving mode, press the button on the unit one or more times until the Energy Saver indicator lights up. Result: x The fan and compressor cycle on and off together. x The fan will continue to run for a short time after the compressor cycles off. If you would like the air conditioner to run in Fan mode, do not press the button. You cannot use the Fan mode in the energy saving mode. 2 To stop the energy saving mode, press the again. Result: button on the unit The fan runs at all times, while the compressor cycles on and off. If you select the Sleep Timer in the Energy Saving mode, the Energy Saving will be cancelled and the air conditioner will start up in the Sleep Timer mode. E-15 Using the W i re l e s s Remote C o n t ro l This chapter indicates how to operate and program your air conditioner with the wireless remote control. E-16 Cooling Your Room You must select the Cool mode if you wish to adjust the: x Cooling temperature x Fan speed when cooling 1 If necessary, press the Result: (On/Off) button. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped lt will start up normally after three minutes. 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: x The unit beeps each time you press the x The air conditioner runs in the Cool mode. button. 3 To adjust the temperature, press the buttons one or more times until the required temperature is displayed. Possible temperatures are between 64°F and 86°F inclusive. Result: x Each time you press the buttons: - The temperature is adjusted by 1°F - The unit beeps x The air conditioner starts cooling, if the room temperature is higher than the selected temperature. x If the room temperature reaches the set temperature, the air conditioner stops cooling, but the fan is still operating. 4 Select the fan speed by pressing the until the required setting is displayed: Low Medium High Result: Each time you press the button one or more times button, the unit beeps. 5 To control the direction of the air flow, refer to page 24. E-17 Ventilating Your Room If the air in your room is stale, you can ventilate the room using the Fan feature. 1 If you wish to discharge stale air, push the ventilation lever on the front of the unit to the right and open position ( Result: ). x The air inside the room circulates and stale air is discharged outside. ). Otherwise, push the ventilation lever to the left and closed position ( Result: x The air simply circulates inside the room. 2 If necessary, press the Result: (On/Off) button. x The air conditioner starts up in the mode selected when the unit was last used. x The unit beeps twice. 3 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: x The unit beeps each time you press the x The air conditioner runs in the Fan mode. button. 4 Select the fan speed by pressing the until the required setting is displayed: Low Medium High Result: Each time you press the button one or more times button, the unit beeps. 5 To control the direction of the air flow, refer to page 24. E-18 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. 1 If necessary, press the Result: (On/Off) button. x The air conditioner starts up in the mode selected when the unit was last used. x The unit beeps. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after three minutes. is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. x The unit beeps each time you press the x The air conditioner runs in the Dry mode. button. 2 If the Result: 3 To adjust the temperature, press the buttons one or more times until the required temperature is displayed. [. . . ] Model AW2490L Power Supply 230-208V~, 60Hz E-27 SAMSUNG ROOM AIR CONDITIONER LIMITED WARRANTY TO ORIGINAL PURCHASER This SAMSUNG brand product, as supplied and distributed by SAMSUNG ELECTRONICS AMERICA, INC. (SAMSUNG) and delivered new, in the original carton to the original consumer purchaser, is warranted by SAMSUNG against manufacturing defects in materials and workmanship for a limited warranty period of: One (1) Year Parts and Labor, Five (5) Years Parts Warranty for Compressor This limited warranty begins on the original date of purchase, and is valid only on products purchased and used in the United States. Warranty repairs must be performed by SAMSUNG's authorized service center. To receive warranty service, the original dated bill of sale must be presented upon request as proof of purchase to SAMSUNG or SAMSUNG's authorized service center. [. . . ]