User manual SAMSUNG AW2492L

[. . . ] AW2492L OWNER'S INSTRUCTIONS Window-type Room Air Conditioner (Cool) E S DB98-15119A Safety Precautions The following safety precautions must be taken when installing and using your air conditioner. 1 The air conditioner must be plugged into its own specific power source, which must be installed in compliance with national wiring, earthing and safety regulations. Depending on national regulations and your specific installation, you may need to install: A circuit breaker For further information on electrical requirements, contact a professional electrician. This device must be installed according to the national electrical rules. 2 Make sure that the unit is correctly ventilated at all times; do NOT place clothing or other materials over it. 3 NEVER spill liquids of any kind into the unit. Should this happen, unplug the unit and contact your installation specialist. 4 Do NOT insert anything between the air outlet blades, as it may damage the inner fan and you may get hurt. Keep children away from the unit. 5 If the supply cord is damaged, it must be replaced by the manufacturerits service agent , or similarly qualified persons in order to avoid a hazard. 6 Do NOT attempt to repair the unit yourself. [. . . ] The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped lt will start up normally after three minutes. 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: The unit beeps each time you press the The air conditioner runs in the Cool mode. button. 3 To adjust the temperature, press the buttons one or more times until the required temperature is displayed. Possible temperatures are between 64°F and 86°F inclusive. Result: Each time you press the buttons: - The temperature is adjusted by 1°F - The unit beeps The air conditioner starts cooling, if the room temperature is higher than the selected temperature. If the room temperature reaches the set temperature, the air conditioner stops cooling, but the fan is still operating. 4 Select the fan speed by pressing the until the required setting is displayed: Low Medium High Result: Each time you press the button one or more times button, the unit beeps. 5 To control the direction of the air flow, refer to page 24. E-17 Ventilating Your Room If the air in your room is stale, you can ventilate the room using the Fan feature. 1 If you wish to discharge stale air, push the ventilation lever on the front of the unit to the right and open position ( Cool/Dry/F an ). Mode Cool/Dry/F an Mode Result: Temp. Swing Fan Speed E. Save r Temp. E. Save r Sleep Swing Sleep Fan Speed Timer Power Timer Power The air inside the room circulates and stale air is discharged outside. ). Otherwise, push the ventilation lever to the left and closed position ( Result: The air simply circulates inside the room. 2 If necessary, press the Result: (On/Off) button. The air conditioner starts up in the Cool mode. The unit beeps twice. 3 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: The unit beeps each time you press the The air conditioner runs in the Fan mode. button. 4 Select the fan speed by pressing the until the required setting is displayed: Low Medium High Result: Each time you press the button one or more times button, the unit beeps. 5 To control the direction of the air flow, refer to page 24. E-18 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity w ithout low ering the room temperature too much. 1 If necessary, press the Result: (On/Off) button. The air conditioner starts up in the Cool mode. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up normally after three minutes. 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. The unit beeps each time you press the The air conditioner runs in the Dry mode. button. Result: 3 To adjust the temperature, press the buttons one or more times until the required temperature is displayed. Possible temperatures are between 64°F and 86°F inclusive. Result: Each time you press the buttons: - The temperature is adjusted by 1°F - The unit beeps The air conditioner starts removing the excess humidity; the quantity of air is adjusted automatically. 4 To control the direction of the air flow, refer to page 24. E-19 Setting the On Timer The On Timer enables you to switch on the air conditioner automatically after a given time. You can select the On timer only when the air conditioner is off. You can select the On timer when the air conditioner operates in the Cool or Dry mode. 1 To set the operating time, press the button one or more times until the required time is displayed. Possible time is between 1 hour and 24 hours inclusive. 2 Press the Result: (Set/Cancel) button to complete the setting. [. . . ] e Model AW2492L Power Supply 230-208V~, 60Hz E-27 SAMSUNG ROOM AIR CONDITIONER LIMITED WARRANTY TO ORIGINAL PURCHASER This SAMSUNG brand product, as supplied and distributed by SAMSUNG ELECTRONICS AMERICA, INC. (SAMSUNG) and delivered new, in the original carton to the original consumer purchaser, is warranted by SAMSUNG against manufacturing defects in materials and workmanship for a limited warranty period of: One (1) Year Parts and Labor, Five (5) Years Parts Warranty for Compressor This limited warranty begins on the original date of purchase, and is valid only on products purchased and used in the United States. Warranty repairs must be performed by SAMSUNG's authorized service center. To receive warranty service, the original dated bill of sale must be presented upon request as proof of purchase to SAMSUNG or SAMSUNG's authorized service center. [. . . ]