User manual SAMSUNG AWT24F1MEB

[. . . ] Air Conditioning Unit - Main Parts and Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 4 OPERATING YOUR AIR CONDITIONER Cooling Your Room . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Airing Your Room . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Switching the Air Conditioner Off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Adjusting the Air Flow Direction Horizontally . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Result: The air conditioner stops operating. E-6 Adjusting the Air Flow Direction Horizontally ENGLISH Depending on the position of the unit in your room, you can adjust the orientation of the inner air flow blades on the right-hand side of the unit, thus increasing the efficiency of the air conditioner. F0/A0/G0 Models Hold the inner air flow blades, and adjust them to the desired direction. F1/F3/A1/A3/G1/G3 Models 1 Set the air flow blade swing switch to the Result: position. The inner blades swing automatically left and right. 2 To stop the blades moving left and right, set the air flow blade swing switch to the position. To stop the blades in a specific position and orient the air flow in the corresponding direction, simply set the switch to the position when the blades are in the desired position. Adjusting the Air Flow Direction Vertically Again depending on the position of the unit in your room, you can adjust the orientation of the outer air flow blades on the right-hand side of the unit. Upwards. Adjust the air flow blades to the desired position, by pushing them upwards or downwards. If you orient the air flow blades downwards and the unit operates in Cool mode for long periods of time, dew may: Form on the surface of the blades Drip from the blades E-7 Selecting Energy Saving Mode (Only F3/A3/G3 models) If you wish to save energy when using the air conditioner, select the energy saving mode by using the Energy Saver switch. This feature is normally used when the room is unoccupied. 1 To select the energy saving mode, set the Energy Saver switch to the ON position. Result: The fan and compressor cycle on and off simultaneously. This results in wider variations of room temperature and humidity. If you want to run the air conditioner in Fan mode, do not turn the Energy Saver switch on. The Fan mode will not operate when the Energy Saver switch is in the ON position. 2 To turn off the energy saving feature, set the Energy Saver switch to the OFF position. Result: The fan runs at all times, while the compressor cycles on and off. Operating Recommendation Here is a recommendation that you should follow when using your air conditioner. Topic Power failure Recommendation If a power failure occurs when the air conditioner is operating, the unit is switched off. When the power returns, the air conditioner starts up again automatically. Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges within which the air conditioner can be used. Mode Cooling Indoor Temperature 21°C to 32°C approx. Outdoor Temperature 21°C to 43°C approx. 21°C to 54°C approx. (Middle East) Indoor Humidity 80% or less If the air conditioner is used at. . . Higher temperature Lower temperature Then. . . The automatic protection feature may be triggered and the air conditioner stopped. A water leakage or some other malfunction may happen if the heat exchanger freezes. Higher humidity levels Water may condense on and drip from the surface of the unit if it is used for long periods. E-8 Cleaning Your Air Conditioner (F0/F1/F3 models) ENGLISH The air conditioner has two or three grille grooves depending on the model. E-9 Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time. IMPORTANT When cleaning the air conditioner, turn it off and pull out the power plug. 1 Hold the air filter handle, slightly pull it to the left side and open the front grille. The removal of the front grille makes it easier to clean the air conditioner. [. . . ] Example: High storage 1 2 3 Open the front grille ; refer to page 9 or 10. Remove the screw located at the lower section of the front grille. It is secured in the section depending on the model. 3-1 Press both sides of the cabinet in the direction of the arrow as shown in the figure. [. . . ]