User manual SAMSUNG CL-29Z50HM

[. . . ] It is dangerous to make any kind of contact with any inside part of this product. This symbol alerts you that important literature concerning operation and maintenance has been included with this product. Note to CATV system installer: This reminder is provided to call CATV system installer's attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I), that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. Important: One Federal Court has held that unauthorized recording of copyrighted TV programs is an infringement of U. S. Certain Canadian programs may also be copyrighted and any unauthorized recording in whole or in part may be in violation of these rights. To prevent damage which may result in fire or electric shock hazard, do not expose this appliance to rain or moisture. Thank You for Choosing Samsung Thank you for choosing Samsung! [. . . ] Press the MENU button to enter the language, and then the "Channel" menu is automatically displayed. 3 Press the VOL+ or VOLbutton to select the desired video signal source. Press the MENU button to enter the video signal source, and then the "Ant Input check" is automatically displayed. continued. . . 3. 1 CHAPTER THREE: TV OPERATION O P E R AT I O N 4 Make sure that the antenna is connected to the TV. And then press the VOL+ or VOL- button to activate "Auto Program" or press the MENU button to skip. (refer to "Auto program" on page 3. 6. ) 5 Press the VOL+ or VOLbutton to move to the hour or minute. Set the hour or minute by pressing the CHv or CHw button. (refer to "Setting the clock" on page 3. 9. ) 6 When you have finished, press the MENU button. The message "Enjoy your watching. . " is displayed. 7 If you want to reset this feature (1)Press the MENU button. (2)Press the CHw button three times to select the Function menu and press the VOL+ button. (3)Press the CHw button to select Plug & Play and press the VOL+ button. The message "Plug & Play" is displayed. Note: Plug & Play feature doesn't work when in the A/V mode. CHAPTER THREE: TV OPERATION 3. 2 O P E R AT I O N Viewing the Menus and On-Screen Displays Viewing the Menus 1 With the power on, press the MENU button. Its left side has four icons: Picture, Sound, Channel, and Function. The on-screen menus disappear from the screen after about thirty seconds. w w 2 Use the CHv and CHw buttons to highlight one of the 4 icons. For example, to select channel 27, press "2", then "7". The TV will change channels when you press the second number. When you use the number buttons, you can directly select channels that were either erased or not memorized. To select a channel over 100, press the +100 button. (For channel 122, press "+100", then "2", then "2". ) To change to single-digit channels (0­9) faster, press "0" before the single digit. (For channel "4", press "0", then "4". ) Using the PRE-CH Button to select the Previous Channel 1 Press the PRE-CH button. The TV will switch to the last channel viewed. To quickly switch between two channels that are far apart, tune to one channel, then use the number button to select the second channel. Then, use the PRE-CH button to quickly alternate between them. w Adjusting the Volume Press the VOL + or VOL­ button to increase or decrease the volume. Using Mute At any time, you can temporarily cut off the sound using the Mute button. 1 Press the MUTE button and the sound cuts off. The word "Mute" will appear in the lower-left corner of the screen. 2 To turn mute off, press the MUTE button again, or simply press either the VOL ­ or VOL + button. CHAPTER THREE: TV OPERATION 3. 8 O P E R AT I O N Setting the Clock 1 Press the MENU button to display the on-screen menu. Press the CH w button three times to select "Function". Press the VOL + button. 2 Press the CH w button to select "Time" menu. Press the VOL + button: The Time menu will appear on the screen, and "Clock" will be selected. 3 Press the VOL + button again (the hours digits will be selected). [. . . ] Press the VOL+ button. 2 Press the CH w button to select the "Caption" menu, then press the VOL+ button. 3 Press the VOL+ or VOL ­ button to turn closed captioning on/off. Misspellings and unusual characters sometimes occur during closed caption transmissions, especially those of live events. There may be a small delay before captions appear when you change channels. These are not malfunctions of the TV. w 4 Press the CH w button to select "Mode". Press the VOL ­ or VOL + button to select "Caption" or "Text". In caption mode, captions appear at the bottom of the screen, and they usually cover only a small portion of the picture. [. . . ]