User manual SAMSUNG CLP-660N/SEE

[. . . ] © 2007 Samsung Electronics Co. , Ltd. This user's guide is provided for information purposes only. All information included herein is subject to change without notice. Samsung Electronics is not responsible for any changes, direct or indirect damages, arising from or related to use of this user's guide. · CLP-610ND, CLP-660N, and CLP-660ND are model names of Samsung Electronics Co. , Ltd. [. . . ] If you are under the DOS environment, the font setting for your machine may be set incorrectly. The toner cartridge is defective or out of toner. Some parts, such as the controller or the board, may be defective. PDF file does not print correctlysome parts are missing in the graphics, text or illustrations. Incompatibility between the PDF file and the Acrobat products. The machine selects print materials from the wrong paper source. Half the page is blank. For many software applications, the paper source selection is found under the Paper tab within the printer properties. Reduce the complexity of the page or try adjusting the print quality settings such as adjusting the resolution. Change the page orientation in your application. Ensure the paper size in the printer driver settings matches the paper in the tray. Or, ensure the paper size in the printer driver settings matches the paper selection in the software application settings you use. The job may be very complex. Redistribute the toner, if necessary. If necessary, replace the toner cartridge. Check the file to ensure that it does not contain blank pages. Contact a service representative. The page orientation setting may be incorrect. The paper size and the paper size settings do not match. Printing the PDF file as an image may enable the file to print. Turn on Print As Image from the Acrobat printing options. Note: It will take longer to print when you print a PDF file as an image. 7. 11 <Troubleshooting> Condition The print quality of photos is not good. Images are not clear. Possible cause The resolution is set to Normal. Suggested solutions Change the resolution to Best in the machine properties window and then try printing again. If you increase the photo size in the software application, the resolution will be reduced. After printing about 100 color pages, there will be no more smell. It is a temporary issue. Printing quality problems If the inside of the machine is dirty or paper has been loaded improperly, you may notice a reduction in print quality. See the table below to clear the problem. Condition Light or faded print Suggested solutions If a vertical white streak or faded area appears on the page: · The toner supply is low. [. . . ] The color tone of Vivid mode produces more Vivid color images than that of Standard mode. Device mode is best used for printing fine lines, small characters and color drawings. The color tone of Device mode may be different from that of monitor, the pure toner colors are used for printing Cyan, Magenta and Yellow colors. ·Fine Edge: It allows users to emphasize edges of texts and fine lines for improving readability and align each color channel registration in color printing mode. ·Resolution(Quality): You can select the printing resolution. [. . . ]