User manual SAMSUNG CMV62002

[. . . ] 01925A CMV62002 7/27/02 5:01 PM Page 1 Video Cassette Recorder Owner's Manual CMV42002 CMV62002 01925A CMV62002 7/27/02 5:01 PM Page ii Safety Instructions RISK OF ELECTRIC SHOCK DO NOT OPEN This symbol indicates high voltage is present inside. It is dangerous to make any kind of contact with any inside part of this product. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol alerts you that important literature concerning operation and maintenance has been included with this product. Note to CATV system installer: This reminder is provided to call CATV system installer's attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. Caution: FCC regulations state that any unauthorized changes or modifications to this equipment may void the user's authority to operate it. [. . . ] Press the MENU button on the remote control when you are finished. VCR FUNCTION SETUP Record speed: Audio output: Tape length: Auto play: Auto repeat: Auto power off: VCR output CH: [ %/] [SP] [MAIN] [T120] [ON] [OFF] [OFF] [3CH] [MENU/EXIT] Auto power off VCR FUNCTION SETUP Access the "VCR FUNCTION SETUP" menu. Press w and to set "Auto power off" to 1Hr or 2Hr. "Auto power off " sets the VCR to turn off automatically. Note: VCR will shut off 1 or 2 hours after the last button is pressed. Record speed: Audio output: Tape length: Auto play: Auto repeat: Auto power off: VCR output CH: [ %/] [SP] [MAIN] [T120] [ON] [OFF] [OFF] [3CH] [MENU/EXIT] 12 01925A CMV62002 7/27/02 5:01 PM Page 13 VCR Setup Setting the VCR Output CH 1 Access the VCR Setup menu. Press w to select VCR Output Channel. VCR FUNCTION SETUP Record speed: [SP] Audio output: [MAIN] Tape length: [T120] Auto play: [ON] Auto repeat: [OFF] Auto power off: [OFF] [3CH] VCR output CH: [ %/] [MENU/EXIT] 2 Press to toggle between VCR output CH3 and CH4. 3 Press MENU 2 times to exit menu, if your TV channel does not match the VCR output channel, the message at right will appear. Set the TV channel so it matches the VCR output channel. Note: The VCR output Channel is set to 3 at the factory. VCR Out channel is changed to CH4. Set TV channel again 13 01925A CMV62002 7/27/02 5:01 PM Page 14 VCR Operation Tape Controls Play and Pause/Still · Press the PLAY button on the remote control or on the front of the VCR to play a video. (If Auto play is selected and the video tape has no safety tab, it will begin playing automatically when you insert it in the VCR. ) · In play or slow motion mode, press the STILL button to stop the tape on a single still frame. Press the button again to resume normal viewing. Fast Forward and Forward Search · Press the FF button when the tape is stopped to fast-forward the cassette at top speed. · Press the FF button once while a tape is playing for forward search. · Press and hold to increase speed by 7 times for tapes recorded at SP speed and 21 times for tapes recorded at SLP speed. Release button to play. Rewind and Reverse Search · Press the REW button when the tape is stopped to rewind the cassette at top speed. · Press the REW button once while a tape is playing for rewind search. · Press and hold button while tape is playing to increase reverse speed by 7 times for tapes recorded at SP speed and 21 times for tapes recorded at SLP speed. Release button to play. F. ADV/SKIP 0 Frame Advance and Skip Search · Press the F. ADV/SKIP button repeatedly to advance a video tape frame by frame in still mode. Press the PLAY button to resume normal viewing. · For Skip Search, press F. ADV/SKIP once to skip ahead 30 seconds. Press the F. ADV/SKIP button twice to skip ahead 60 seconds, three times to skip ahead 90 seconds and four times to skip ahead 120 seconds. SLOW Slow Motion · Press the SLOW + or - button while a cassette is playing for slow motion. · Press the SLOW buttons repeatedly to vary slow motion speed from 1/5 to1/30 of normal playback. Press the PLAY button twice to resume normal viewing. REPLAY Replay · Press the REPLAY button when a video is playing at normal speed or in slow motion, and the VCR will rewind for about five seconds of material in SP mode or about fifteen seconds in SLP mode, then play back the section again. 100 SHUTTLE Shuttle Buttons · Shuttle buttons on the remote control offer one-touch search speed playback. · Press 6 to advance or 4 to reverse playback in play mode. [. . . ] 2 watts off Dimensions: Weight: 360mm(W) X 94mm(H) X 238mm(D) 14. 2''(W) X 3. 7''(H) X 9. 4''(D) 2. 8kg/6. 2lbs Your VCR can receive 68 broadcast TV channels or up to 125 unscrambled cable channels. Check your local cable company for complete compatibility requirements. Type Number of Channels 12 56 113 Channel List On Air CATV VHF (Channels 2~13) UHF (Channels 14~69) Channels 14~22 (A~I) Channels 23~94 (J~W+58)and 100~125(W+59-W+84) Channels 95~97 (A~5, A~4, A~3)* Channels 98~99(A~2, A~1)* Channel 01 (5A)* Total 181 5: These channels are not available in Canada. 24 01925A CMV62002 7/27/02 5:01 PM Page 25 LIMITED WARRANTY TO ORIGINAL PURCHASER This Curtis Mathes brand product, as supplied and distributed by Curtis Mathes and delivered new, in the original carton to the original consumer purchaser, is warranted by Curtis Mathes against manufacturing defects in materials and workmanship for a limited warranty period of: Ninety (90) Days Labor and One (1) Year Parts This limited warranty begins on the original date of purchase, and is valid only on products purchased and used in the United States. To receive warranty service, the purchaser must contact Curtis Mathes for determination of problem and service procedures. Warranty service can only be performed by a Curtis Mathes authorized service center. [. . . ]