User manual SAMSUNG CS-25M20RQQ

[. . . ] Connecting Headphones The 3 (headphone) jack is used for watching a television programme without disturbing the other people in the room. Prolonged use of headphones at a high volume may damage your hearing. 1 2 3 4 5 6 On-screen menu display Volume adjustment Channel selection Remote control sensor Indicator Power on/off Connecting to an Aerial or Cable Television Network Connect the aerial or network input cable to the 1 (75 coaxial socket). To view television channels correctly, a signal must be received by the set from one of the sources: an outdoor aerial, cable television network, or satellite network. If you are using an indoor aerial, you may need to adjust it when tuning your television until you obtain a picture that is both sharp and clear. [. . . ] To switch the television back on, simply press it again. Do not leave the television in standby mode for long periods of time (when you are away on holiday, for example). Turn the television off by pressing the "I" button (On/Off) on the front (or side) of the television. It is best to unplug the set from the mains and aerial. Function - Plug & Play When the television is initially powered on, several basic customer settings proceed automatically and subsequently. 1 If the television is in standby mode, press the POWER button on the remote control. It flickers for a little while, and then Language menu is displayed. Plug & Play 4 Press the oe or button to search the channels. To stop the search, press the MENU button. When the channel searching has finished, the Time menu is displayed with Clock selected. P1 471 MHz 48% Exit 5 Time Clock Move -- : -- AM Exit 2 Select the appropriated LANGUAGE ENGLISH language by pressing the . . . FRANÇAIS TÜRKÇE or button. Input Check If any language is not Auto Store Exit selected, the language menu will disappear about 30 seconds later. Make sure that the antenna is connected to the television (refer to page 1). When you scan P 2 : Added P 3 : Added through the stored channels, P 4 : Added those you have chosen to skip are not displayed. All of the Select Adjust Exit channels that you did not specifically choose to skip are displayed during scanning. Color System: AUTO/PAL/SECAM/NTSC4. 43/NTSC3. 58 NTSC4. 43 is a `trick' playback mode used by special VCR's to play PAL-recorded videos in NTSC mode. Sound System: B/G, I, D/K, M Search (When you do not know the channel numbers): The tuner scans the frequency range until the first channel or the channel that you selected is received on the screen. (Programme number to be assigned to a channel) Store (When you store the channel and associated programme number) Select Added or Erased by pressing the oe or button repeatedly. Channel - Sort This operation allows you to change the programme numbers of stored channels. This operation may be necessary after using auto store. Channel Sort From To Store :P 1 : P-:? If there is no sound or abnormal sound, re-select the sound standard required. From: Channel number to be changed. To: New channel number to be identified. Store: Confirmation the exchange of channel numbers. Select Adjust Exit English - 4 Channel - Fine Tune If the reception is clear, you do not have to fine-tune the channel, as this is done automatically during the search and store operation. If however the signal is weak or distorted, you may have to fine-tune the channel manually. Channel Fine Tune Tune Store Erase : -/+ :?:? Function - Child Lock Function This feature allows you to Child Lock prevent unauthorized users, Child Lock : On such as children, from watching Prog. No. unsuitable programmes by muting out video and audio. Child Lock cannot be released Select Adjust Exit using front (or side) panel buttons. [. . . ] Check that you have pressed the "I" button (On/Off) and the POWER button. Check the picture contrast and brightness settings. Normal picture but no sound Check the volume. Check whether the volume MUTE button on the remote control has been pressed. [. . . ]