User manual SAMSUNG DED65EL8

[. . . ] Make sure to read the following and use the dehumidifier properly. Keep this user's manual in a handy place so that you can find it whenever you need to see it after reading this manual thoroughly. WARNING CAUTION WHEN INSTALLING This indicates the possibility of serious injury or death. This indicates the possibility of serious injury or damage to environments when operated incorrectly. Do not install the unit in a place where it is exposed to inflammable gas leakage. If the unit is flooded, please contact a service center. (page 20. ) REGARDING THE POWER SOURCE Do not pull the power cord or touch the power plug with wet hands. Do not bend the power cord or Do not use multiple sockets weigh down the dehumidifier. for the power. Do not use an electric wire or plug that is damaged or loose. Use the rated current fuse. If the power plug is damaged, have it replaced by a qualified professional or contact Samsung. [. . . ] If the Off Timer is set and a power failure occurs, the Off Timer must be set again. This product is for use in temperatures above 38 degrees F, do not operate this unit if it is exposed to temperatures below 38 degrees F. E-10 Selecting the Humidity Mode You must select the Humidity Control button if you wish to lower the humidity. You can also set the Fan speed. 1 Press the button to turn the unit on. : The product will stop once the button is pressed again. 2 Please press the or buttons on the Humidity Control area to adjust the humidity. or The humidity level can be adjusted from 35% to 80% by pressing the buttons. The humidity adjusts in 5% increments. 3 Press the Result: button to select the fan speed. When pressing the button, the Fan Speed will switch between Low and High. E-11 Selecting the Continuous Run Mode Pressing the Continuous Run button allows the dehumidifier to continuously run in humidity mode. 1 Press the button to turn the unit on. 2 Press the Result: button. You are not able to adjust the humidity. Note The dehumidifier will stop when the Bucket Full indicator lights up. For more information see page 15. E-12 Selecting the Self Dry Mode Self Dry mode can be used to clean the unit and removes excess humidity. You can operate Self Dry mode when the dehumidifier is powered on or off. Power On 1 Press the Result: button. The [ ]symbol and humidity % will be displayed. Self Dry mode can be canceled by pressing the button. 2 Press the Result: button. Only the [ ] symbol will be displayed and the fan speed will automatically adjust to low. The inside moisture of the unit is removed in 30 minutes. In Self Dry mode the product will power off after 30 minutes. Power Off 1 Press the Result: button. The [ ] symbol will be displayed, and Self Dry mode will start. Self Dry mode can be canceled by pressing the or button. The inside moisture of the unit is removed in 30 minutes. [. . . ] Please do not wrap the air filter when cleaning it. 4 Insert the air filter. 5 Slide the water bucket back into place. : If the water bucket is incorrectly inserted, the Bucket Full indicator will go on, and the product will not operate. Note We recommend cleaning the air filter twice a week. If the unit is in an area where there is a lot of dust please clean the air filter once a week. E-17 Cleaning the Dehumidifier Cleaning the Water Bucket 1 Hold the holes on both side of the water bucket and slide it out. 2 Pull the bucket cover up to remove it. 3 Clean the water bucket with a warm, damp soft cloth. 4 Place the bucket cover back into place by pushing it down. 5 Slide the water bucket back into place. [. . . ]