User manual SAMSUNG DMT610RHW/XAC INSTALLATION GUIDE

[. . . ] DMT800 Series DMT610 Series DMT400 Series DMT350 Series DW7933 Series DW80F800 Series DW80F600 Series Dishwasher installation guide These installation instructions are intended for use by qualified installers. STOP If you are having problems installing this dishwasher Please call : 1-800-SAMSUNG (726-7864) for assistance : www. Com imagine the possibilities Thank you for purchasing this Samsung product. To receive more complete service, please register your product at www. [. . . ] Ensure that the circuit breaker connected to the dishwasher is off. The power cable must not extend more than 4 ft (1. Check the plastic base assembly to ensure that it is intact 2. Check the dishwasher’s feet to ensure they are in place and can be adjusted so you can level and secure the dishwasher. Check all the visible components on the bottom of the dishwasher to ensure they are intact and secure. Check the door latch, the operation of the hinges, and confirm the door is properly secured to the dishwasher. Check the hot water connection on the front left-side of the base of the dishwasher. The mounting plate should be secured to the front of the base, the threads inside the connection should be smooth and shiny, and the area should be clean and free of any debris. Check the plastic Brake and Sensor cases to ensure these assemblies are not cracked and that all connections are secure. Check the drain hose for any holes or deformities that could allow a water leak during draining. Confirm the junction box cover is secured to the junction box on the front right-side of the base of the dishwasher. Confirm the electrical box was not damaged during shipping and that it is secured to the base of the dishwasher. Confirm there are no dents or scratches on the front of the dishwasher. Check the edges of the doors for any roughness or cracking 3. Check the control panel to ensure it is clear and unscratched, and that all the control markers are in their proper places. Confirm you have all the parts listed in Step 1 on page 6. Ensure that the circuit breaker and water supply valve are turned off before proceeding with the following steps. CAUTION Before you move or lay down the dishwasher for installation, make sure to adjust the height of the legs so the legs are as short as possible. Level the dishwasher by adjusting the height of the legs after you have the dishwasher in place. Wrap Teflon tape around the threads of the 90˚ elbow, and then attach the elbow to the Inlet valve (Figure 4- B). Tighten until the elbow is tight and pointing towards the water hose channel in the base of the dishwasher (about 4 o'clock). To prevent the inlet valve from being blocked, make sure that the Teflon tape does not enter the valve. [. . . ] In the junction box located at the front bottom right of the dishwasher, find the three power wires from the dishwasher including the grounding line. Pass the power cable through the strain relief, and then into the junction box (Figure 13). Connect the black wire of the dishwasher to the black wire of the power cable by insertng both into a wire nut. And then rotating the wire connector as shown in Figure 14. [. . . ]