User manual SAMSUNG DP700A3D

[. . . ] B) Install the anti-tip device to the structure and/or the range at rear right (or rear left) of the range bottom. C) Engage the range to the anti-tip device by leveling leg at rear right (or rear left) of the range bottom. D) Re-engage the anti-tip device if the range is moved. e) See installation instructions for details. [. . . ] You must use a 3-wire or 4-wire, single-phase A. If the electrical service provided does not meet the above specifications, have a licensed electrician install an approved outlet. use only a 3-conductor or a 4-conductor UL-listed range cord. These cords may be provided with ring terminals on wire and a strain relief device. a range cord rated at 40 amps with 125/250 minimum volt range is required. A 50 amp range cord is not recommended but if used, it should be marked for use with nominal 13⁄8” diameter connection openings. Care should be taken to center the cable and strain relief within the knockout hole to keep the edge from damaging the cable. €¢ Because range terminals are not accessible after range is in position, flexible service conduit or cord must be used. ACCEssING ThE PoWER CoRD CoNNECTIoN Remove the rear access cover and loosen the screw with a screwdriver. The terminal block will then be accessible. Terminal block Access cover Specified power-supply-cord kit rating Range rating, watts 120/240 volts 3-wire 8, 750 - 16, 500 Specified rating of power-supply-cord kit, amperes 40 or 50A Diameter (inches) of range connection opening Power cord 13/8” Conduit 11/8” 6_ Connecting the power Installation_XAC_DG68-00109F-01_EN+CFR. indb 8 2012-02-21 �� 6:48:50 sTEP 4. INsTAllING ThE CoNDuIT Remove the conduit connection plate from the rear of the drawer body and rotate it as shown below. The conduit hole (11/8”) must be used. Then thread the conduit cord through the body of the strain relief and fasten the ring. Installing a 3-wire conduit • Aluminum building wire may be used but it must be rated for the correct amperage and voltage to make the connection. Connect wires according to Step 4 depending on the number of wires. • Wire used , location and enclosure of splices , etc. , must conform to good wiring practices and local codes. Loosen the 3 lower terminal screws from the terminal block. Insert the center bare wire (white/neutral) tip through the bottom center terminal block opening. On certain models, the wire will need to be inserted through the ground strap opening and then into the bottom center block opening. [. . . ] Go to step 5 and proceed with the installation. black Red White Neutral terminal Ground strap Ground plate Wire tips Black White Red Ground wire (Green) sTEP 5. REPlACING ThE ACCEss CoVER Replace the access cover on the range back. To replace the wire cover, insert double projections in the pockets located below the opening and tighten the screw. [. . . ]