User manual SAMSUNG DTB-9500F

[. . . ] Before cleaning, disconnect the STB from the wall socket. Use a cloth lightly dampened with water(no solvents) to clean the exterior. Ensure that free airflow is maintained around the STB. Never store the STB where it is exposed to direct sunlight or near heating equipment e. g. [. . . ] Be certain to remove the black cover from the optical output before inserting the cable. Do not connect both optical and coaxial cables. This may damage your audio system. ENG-18 D I G I T A L T E R R E S T R I A L H D T V R E C E I V E R ENG-19 DTB-9500F To select the resolution: DTB-9500F CONNECTING YOUR STB BASIC FUNCTIONS 1. Display Screen Before you can view the television program, you must perform the installation. Therefore you will see only menu images at first. After the television channels have been programmed, you will see the following picture (banner) each time you switch channels: Selecting the Resolution and the DTV Output Signal You can select the video output appropriate to the connected TV or monitor mode. RESOLUTION Select a resolution by using the RESOLUTION switch at the back of the HD receiver referring to the following table. 576p 576i 720p 1080i Channel Number Channel Name Reserved Date/Time Parental Rating HD/SD Dolby ENG To select the DTV output signal: DTV OUTPUT Progress YPBPR RGB Program Information Teletext Subtitle Select the output signal by using the DTV OUTPUT switch at the back of the HD receiver referring to the following table. Select the output signal by using the DTV OUTPUT switch at the back of the HD receiver referring to the following table. YPBPR: Select YPBPR when the TV is connected to the Component (YPBPR) output port of the HD receiver. (The signal is not output through the RGB and DVI output. ) RGB: Press the INFO key in view mode. Select the channel by pressing the NUMERICAL 0~9 keys or TV/RADIO key to move to TV or Radio channel. / keys and select the You will also see this picture each time you change channels. When you press the TV/RADIO key on the Remote Control Unit, TV and Radio program are toggled. When the teletext application is active following keys can be used: 5. View Favorite Channel Press the FAV CH key to view the stored favorite channels. Each time the FAV CH key is pressed, the next channel from the stored favorite channels is shown (i. e. For more information, see the favorite channels item. (Refer to page 28) NUMERICAL keys: 0. . . . . 9 are used to change main page. Then in the left upper corner will be visible number of the main page. If the broadcasting program provides this page after the moment (usually about 20s), this page will be visible. / keys are used to change main page , just (+1) for key and (-1) for key. / keys are used to change Next/Previous subpage number. Sometimes broadcaster send one or more subpages on one main page. To change sub-page number just press or key, if subpages will be exist in STB memory then next/previous subpage will be displayed. [. . . ] Press Exit to exit the menu. Note : In Channel Change mode, you will see only the channels that you have already set. Select "Change PIN Code" in the System menu. Input the Current PIN Code using Numerical key, then press the SELECT ( ) key or key to move to New PIN Code. (The factory preset PIN Code : 0000. ) Input a New PIN Code using NUMERICAL key, then press the SELECT ( ) key or key to move to Confirm PIN Code. To confirm, you need to enter the New PIN Code again. [. . . ]