User manual SAMSUNG DV316HEC

[. . . ] Precision drying never got easier than with Samsung. Freshen Up Cycle Want to freshen up a garment that doesn't need washing, but could deserve a little help after last night's party. Our Freshen Up Cycle removes odors, adding that extra freshness to give more mileage to your clothes. Time Saving Our cycles are designed with you in mind. All our dryers are designed to dry your clothes in less time. . . Giving you time for more important things in life. Energy Saving Samsung dryers are super energy efficient, using only 3. 01 kWh per pound of laundry. [. . . ] The dryer frame is grounded to the neutral conductor at the terminal block. A 4-WIRE SYSTEM CONNECTION is required for new or remodeled construction, mobile homes, or if local codes do not permit grounding through neutral. If the 4-wire system is used, the dryer frame cannot be grounded to the neutral conductor at the terminal block. Refer to the following instructions for 3- and 4-WIRE SYSTEM CONNECTIONS. Insert the power cord with a UL-listed strain relief through the hole provided in the cabinet near the terminal block. Do not loosen the nuts already installed on the terminal block. Apply pipe joint compound or about 1 1/2 wraps of Teflon tape over all threaded connections. NOTE: Pipe joint compound must be resistant to the action of any liquefied petroleum gas. An additional fitting is required to connect the 3/4" (1. 9 cm) female thread end of a flexible connector to the 3/8" (1 cm) male threaded end on the dryer. Securely tighten the gas line fitting over threads. Check all gas connections for leaks using a soap solution. In order to confirm gas ignition, check the exhaust for heat. FINAL INSTALLATION CHECKLIST Dryer is plugged into electrical outlet and properly grounded. Exhaust ductwork is hooked up and joints taped. Use rigid or stiff-walled flexible metal vent material. Dryer is level with all legs firmly on the floor. Gas models ­ gas is turned on with no gas leaks. Start your dryer to confirm that it runs, heats, and shuts off. SAMSUNG Dryer Owner's Instructions A-9 Installation Instructions Dryer Exhaust Tips WARNING: Plastic or non-metal flexible duct presents a potential fire hazard. 1 2 3 4 1. Use 4" diameter rigid metal duct. Tape all joints, including at the dryer. Clean all old ducts before installing your new dryer. Be sure vent flap opens and closes freely. Inspect and clean the exhaust system annually. Don't let a poor exhaust system slow drying by: 1 1. [. . . ] Remove the door so that animals and small children cannot get trapped inside the appliance. DECLARATION OF CONFORMITY This appliance complies with UL2158. SPECIFICATION TYPE DIMENSION Div A. Width WEIGHT HEATER RATING POWER CONSUMPTION NO HEAT HEATING FRONT LOADING DRYER Inches (cm) 38" (96. 5) 27" (68. 6) 56. 8 kg 5300 W 268 W 5445 W Div C. Depth Inches (cm) 49" (124. 5) 30. 25" (77. 0) F-3 SAMSUNG Dryer Owner's Instructions Appendix CYCLE CHART Default Cycle Temp control Sensor Dry Normal High (Medium) Sensor dry level Normal dry Normal dry Normal dry Normal dry Normal dry Normal dry Time 44 min 60 min 52 min 34 min 29 min 29 min 30 min 40 min 25 min 20 min 30 min 25 min Drying Time 39 min 55 min 47 min 24 min 24 min 24 min 25 min 35 min 20 min Cooling Time 5 min 5 min 5 min 10 min 5 min 5 min 5 min 5 min 5 min 20 min 5 min Wrinkle prevent Time 90 min 90 min 90 min 90 min 90 min 90 min - Heavy Duty High (No change) Towels Perm Press Delicates Extra Delicates High (Medium) Medium Low (No change) Low (No change) Extra Low (No change) Manual Dry Freshen Up High (No change) Time Dry Wrinkle Release Air Fluff Quick Dry High Medium - (No change) High SAMSUNG Dryer Owner's Instructions F-4 Appendix SAMSUNG DRYER LIMITED WARRANTY TO ORIGINAL PURCHASER This SAMSUNG brand product, as supplied and distributed by SAMSUNG ELECTRONICS AMERICA, INC. (SAMSUNG) and delivered new, in the original carton to the original consumer purchaser, is warranted by SAMSUNG against manufacturing defects in materials and workmanship for a limited warranty period of: One (1) Year All Parts and Labor, Two (2) Years Control Board Parts This limited warranty begins on the original date of purchase, and is valid only on products purchased and used in the United States. [. . . ]