User manual SAMSUNG DV330AEB/XAA

[. . . ] DV350AE* DV350AG* Gas and Electric Dryer user manual imagine the possibilities Thank you for purchasing this Samsung product. To receive more complete service, please register your product at www. samsung. com/register DV350-02821A_EN. indd 1 2010-01-28 ø¿» 3:25:56 features 1. Extra Large Capacity Ultra drying capabilities are at your fingertips!capacity dryer circulates more air through your clothes, drying them faster for a wrinkle-free result. 2. [. . . ] An additional fitting is required to connect the 3/4" (1. 9 cm) female thread end of a flexible connector to the 3/8" (1 cm) male threaded end on the dryer. Securely tighten the gas line fitting over threads. Check all gas connections for leaks using a soap solution. If bubbles appear, tighten the connections and recheck. DO NOT use an open flame to check for gas leaks. 3-WIRE system connections 1. Loosen or remove the center terminal block screw. Connect the neutral wire (white or center wire) of the power cord to the center, silver-colored terminal screw of the terminal block. Connect the other wires to outer terminal block screws. Insert the tab of the terminal block cover into your dryer's rear panel slot. Secure the cover with a hold-down screw. Neutral grounding wire (green/yellow) 3. Center silver-colored terminal block screw 4. 3/4" (1. 9 cm) UL-listed strain relief WARNING If converting from a 4-wire electrical system to a 3-wire, the ground strap must be reconnected to the terminal block support to ground the dryer frame to the neutral conductor. Installing your dryer _17 DV350-02821A_EN. indd 17 2010-01-28 ø¿» 3:26:10 installing your dryer 4-WIRE system connections 1. Connect the ground wire (green or unwrapped) of the power cord to the external ground conductor screw. Connect the neutral wire (white or center wire) of the power cord and the appliance ground wire (green with yellow stripes) under the central screw of the terminal block. Connect the other wires to the outer terminal block screws. Insert the tab of the terminal block cover into your dryer's rear panel slot. Secure the cover with a hold-down screw. Green or bare copper wire of power cord 3. Center silver-colored terminal block screw 5. With a level, check your dryer and make necessary adjustments to the leveling legs. At this time, make sure all gas connections (on gas models), exhaust and electrical connections are complete. [. . . ] To receive warranty service, the purchaser must contact SAMSUNG for problem determination and service procedures. Warranty service can only be performed by a SAMSUNG authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to SAMSUNG or SAMSUNG's authorized service center. SAMSUNG will provide in-home service during the warranty period at no charge, subject to availability within the contiguous United States. [. . . ]