User manual SAMSUNG DV338AEB

[. . . ] DV338AEW DV338AGW Gas and Electric Dryer user manual imagine the possibilities Thank you for purchasing this Samsung product. To receive more complete service, please register your product at www. samsung. com/global/register DV338AER-02571A_EN. indd 1 2008-02-14 ¿ÀÈÄ 4:23:30 features 1. Extra Large Capacity Ultra drying capabilitlites are at your fingertips!capacity dryer circulates more air through your clothes getting them dry faster, for a wrinkle-free result. 2. Steam cycle This cycle sprays a small amount of water into the dryer drum after several minutes of tumbling with heat. [. . . ] A 4-WIRE SYSTEM CONNECTION is required for new or remodeled construction, mobile homes, or if local codes do not permit grounding through neutral. If the 4-wire system is used, the dryer frame cannot be grounded to the neutral conductor at the terminal block. Refer to the following instructions for 3- and 4-WIRE SYSTEM CONNECTIONS. Insert the power cord with a UL-listed strain relief through the hole provided in the cabinet near the terminal block. Do not loosen the nuts already installed on the terminal block. Use a 3/8" (1cm) deep well socket. 16_ installing your dryer DV338AER-02571A_EN. indd 16 2008-02-14 ¿ÀÈÄ 4:23:40 6. Apply pipe joint compound or about 1 1/2 wraps of Teflon tape over all threaded connections. Pipe joint compound must be resistant to the action of any liquefied petroleum gas. 01 installing your dryer Connect the gas supply to your dryer. An additional fitting is required to connect the 3/4" (1. 9 cm) female thread end of a flexible connector to the 3/8" (1 cm) male threaded end on the dryer. Securely tighten the gas line fitting over threads. Check all gas connections for leaks using a soap solution. If bubbles appear, tighten the connections and recheck. DO NOT use an open flame to check for gas leaks. 3-WIRE system connections 1. Loosen or remove the center terminal block screw. Connect the neutral wire (white or center wire) of the power cord to the center, silver-colored terminal screw of the terminal block. Connect the other wires to outer terminal block screws. Insert the tab of the terminal block cover into your dryer's rear panel slot. Secure the cover with a hold-down screw. Neutral grounding wire (green/yellow) 3. Center silver-colored terminal block screw 4. 3/4" (1. 9 cm) UL-listed strain relief WARNING If converting from a 4-wire electrical system to a 3-wire, the ground strap must be reconnected to the terminal block support to ground the dryer frame to the neutral conductor. installing your dryer _17 DV338AER-02571A_EN. indd 17 2008-02-14 ¿ÀÈÄ 4:23:40 installing your dryer 4-WIRE system connections 1. [. . . ] To receive warranty service, the purchaser must contact SAMSUNG for problem determination and service procedures. Warranty service can only be performed by a SAMSUNG authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to SAMSUNG or SAMSUNG's authorized service center. SAMSUNG will provide in-home service during the warranty period at no charge, subject to availability within the contiguous United States. [. . . ]