User manual SAMSUNG DVD-R2000

[. . . ] Safety Instructions TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER(OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol indicates "dangerous voltage" inside the product that presents a risk of electric shock or personal injury. This symbol indicates important instructions accompanying the product. CAUTION: DVD PLAYERS USE AN INVISIBLE LASER BEAM WHICH CAN CAUSE HAZARDOUS RADIATION EXPOSURE IF DIRECTED. [. . . ] (Discs which are recorded with LPCM or DTS will not work. When the DIGITAL OUTPUT is set to BITSTREAM in the SETUP MENU, the 3D Sound function will not work. ) Using the 3D Sound Function (Except MP3) 1 2 3 During playback, press the 3D/+100 button on the remote. The 3D SOUND mark will be displayed on screen. (Be sure the DIGITAL OUTPUT is set to PCM. See page 38. ) Press the LEFT/RIGHT button to turn the 3D Sound feature on or off. To make the screen disappear, press the 3D/+100 button again. NOTE · 3D Sound is possible only on discs recorded using DOLBY SURROUND or DOLBY DIGITAL. However, some of these discs do not contain rear channel sound signals. · Depending on the disc, the 3D Sound function may not work. 29 To Watch TV & VCR Playback (or Other Equipment) Watching TV First check that the Tuner Mode is matched with the ANT input. (TV:AIR or CATV:CABLE) (See page 34) Then, turn on the power of the DVD-R2000 and your TV. 1 Select a TV channel you desire to watch with the NUMBER buttons on the remote control. - If you select 125CH; Press . 2 You can also select a TV channel with the CHANNEL UP/DOWN buttons. For this operation, you need to make settings as below. - Select the TV(AIR) Signal or CATV Signal in the Tuner Mode of General Options, then use the Auto Scan to select channels automatically. Then, use Add/Delete Channel Mode to delete unnecessary channels. (see page 33) Viewing VCR Playback First check that the external input 1 or 2 on the back of DVD-R2000 is connected to a VCR. (L3 at the front of DVD-R2000) Then, turn on the power of the DVD-R2000, TV and VCR. 1 2 While in stop mode, select L1, L2 or L3 with the RETURN/INPUT or CHANNEL UP/DOWN buttons on the remote. (If the VCR is connected to terminal 1 of DVD-R2000, select L1 with Channel UP/DOWN button). Press the PLAY button of VCR. 30 If You Want to Record a TV Program or Line Input Signal You can use a DVD-RAM disc to record any program or a component connected to a line input. First have a recordable RAM disc prepared. Release the write protect of the RAM disc. (The record protector is located at the left bottom of RAM disc cartridge. ) 1 2 Put the RAM disc into the TRAY. - If the RAM disc is not formatted yet, press the ENTER button by selecting Format Disc on the General Options in the setup menu. (See page 36. ) To record a TV program: Select a broadcast channel with the CH UP/DOWN button or NUMBER buttons. To record a line input signal: Select the LINE (L1, L2, L3) that is connected to the external component with the RETURN/INPUT or CHANNEL UP/DOWN buttons. 3 Press the MODE button to change the record mode. - RECORD MODE: FP : High quality record mode. [. . . ] Prior to returning any product for warranty service, the purchaser must contact SAMSUNG for problem determination and service procedures. SAMSUNG does not warrant uninterrupted or error-free operation of the product. All replaced parts and products become the property of SAMSUNG and must be returned to SAMSUNG. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. [. . . ]