User manual SAMSUNG DVD-V340

[. . . ] Instruction Manual DVD-V540 DVD-V440 DVD-V340 STANDBY/ON OPEN/CLOSE OK ® PAL www. samsung. com. au Remote Control Overview (DVD-V540) (DVD-V440/DVD-V340) STANDBY/ON OPEN/CLOSE STANDBY/ON OPEN/CLOSE OK OK Contents Foreword Safety Instructions . 4 DVD-VCR Overviews Front View of the DVD-VCR . 5 6 6 7 Using the Timer Programming Feature . 23 Adjusting Picture Alignment Manually . [. . . ] - Select "Others" if the language you want is not listed. , buttons to select English. - Select "Automatic" if you want the subtitle language to be the same as the language selected as the audio preference. Subtitle Language Automatic Subtitle 6 Press the OK button. - English is selected and the screen returns to Language Setup menu. - Select "Others" if the language you want is not listed. Some discs may not contain the language you select as your initial language; in that case the disc will use its original language setting. - English is selected and the screen returns to Language Setup menu. ENG-30 Setting Up the Audio Options 1 With the unit in Stop mode, press the MENU button. 2 Select DVD using , buttons, then OK or button. DTS 1. On : Setup Setup Display Setup Setup : Doesn't output digital signal. Outputs DTS Bitstream via digital output only. Select DTS when connecting to a DTS Decoder. Dynamic Compression 1. On : Select this when the amplifier connected to the player is not 96KHz compatible. In this case, the 96KHz signals will be down converted to 48KHZ. Off : Select this when the amplifier connected to the player is 96KHz compatible. In this case, all signals will be output without any changes. 3 Select Audio Setup using the OK or button. , buttons, then press 4 Use the , buttons to select the desired item. Then press the OK or button. Dolby Digital Out MPEG-2 Digital Out DTS PCM Down Sampling · How to make the SETUP menu disappear or return to menu screen during set up; Press RETURN or button. Select PCM when using the Analog Audio Outputs. Bitstream : Converts to Dolby Digital Bitstream (5. 1CH). Select Bitstream when using the Digital Audio Output. · Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby Laboratories. · "DTS" and "DTS Digital Out" are trademarks of Digital Theater Systems, Inc. Be sure to select the correct Digital Output or no audio will be heard. Select PCM when using the Analog Audio Outputs. Bitstream : Converts to MPEG-2 Digital Bitstream (5. 1CH or 7. 1CH). Select Bitstream when using the Digital Audio Output. ENG-31 Setting Up the Display Options 1 With the unit in Stop mode, press the MENU button. , buttons, then OK or TV Aspect Depending on the type of television you have, you may want to adjust the screen setting (aspect ratio). [. . . ] Carry out the instructions "Tuning Your Television for the DVDVCR" (see page 9). Carry out the instructions "Setting the DVD-VCR output Channel" (see page 14), move the channel number several channels down from the original setting. Replace the aerial plug into the socket marked (aerial symbol) on the rear of the DVD-VCR. Re-tune your TV to the DVD-VCR again by following instructions "Tuning Your Television for the DVD-VCR" (page 8). [. . . ]