User manual SAMSUNG DVD-V6500

[. . . ] User's Manual DVD-V6500 STANDBY/ON OPEN/CLOSE OK PAL/NTSC www. samsung. com Safety Instructions Getting Started The following illustrations represent precautions. The lightning bolt is a warning sign alerting you to dangerous voltage inside the product. Refer to service personnel. DO NOT expose the DVD-VCR to extreme temperature conditions (below 5°C and above 40°C) or to extreme humidity conditions (less than 10% and more than 75%). DO NOT expose the DVD-VCR to direct sunlight. DO NOT expose the DVD-VCR to any liquids. DO NOT place any objects on the DVD-VCR or remote control. During a storm and/or lightning, unplug the DVD-VCR from the mains jack and aerial. If the remote control is not used for a long period of time, remove the batteries and store it in a cool, dry place. THIS DEVICE IS NOT FOR USE IN INDUSTRIAL ENVIRONMENTS This product incorporates copyright protection technology that is protected by method claims of certain U. S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. [. . . ] Otherwise, the cassette is played automatically. · When a cassette is loaded, the tape position is optimized automatically to reduce disturbance (Digital Auto Tracking). When playing a cassette, if the end of the tape is reached, the cassette is rewound automatically. NTSC tapes can be played back but cannot be recorded with this DVD-VCR. 3 Playing Back Press the I (stop) button to stop the playback. Press the (eject) button to eject the playback. Adjusting Picture Alignment Manually · Playing a Cassette . 36 · Adjusting Picture Alignment Manually . 36 · Selecting the Audio Output Mode . 37 · Playing a Cassette in Slow Motion . 37 · Playing a Sequence Frame by Frame . 37 · Playing a Sequence at Variable Speeds . 37 · Searching for a Specific Sequence . 40 This feature allows you to adjust the alignment manually to obtain the best possible picture. When noise bars or streaks appear during playback, adjust alignment manually by pressing the TRK ( or button until the picture is clear and stable. N The image is adjusted. 36 - English Selecting the Audio Output Mode You can select the mode in which the sound is reproduced on the loudspeakers and AV outputs. Press the AUDIO button on the remote control until the required option is displayed. Option L R MIX MONO LR Description Used to listen to the sound on the left Hi-Fi channel. Used to listen to the sound on the right Hi-Fi channel. Used to listen to the mixed sound of the Hi-Fi and normal channels. Used to listen to the sound on the normal mono channel. Used to listen to Hi-Fi stereo sound on the left and right channels · When playing back tapes recorded in Hi-Fi, the sound switches to Hi-Fi after five seconds of Mono. Playing a Sequence Frame by Frame You can · Stop the cassette at a given frame (image) · Advance one frame at a time No sound is heard when playing back frame by frame. 1 Press the : · ll button to start playing the cassette. · ll button again to make still mode. · F. ADV button to advance frame by frame. · ll button to return to normal playback. [. . . ] Replace the aerial plug into the socket marked (aerial symbol) on the rear of the DVD-VCR. Re-tune your TV to the DVD-VCR again by following instructions "Tuning Your Television for the DVD-VCR" (see page 15). If the problem still exists repeat steps 1 to 5 moving several more channels away from the original setting. If when tuning in your TV to the DVD-VCR TV does not find the Screen or the pattern when found suffers from interference, it may be due to the DVD-VCR output channel clashing with the normal TV transmissions in your area. To prevent this you will need to change the DVD-VCR output channel in the following way Reference 64 - English Troubleshooting Guide (DVD) Problem Solution Page Disc does not play. N Ensure that the disc is installed with the label side facing up. [. . . ]