User manual SAMSUNG FH052EAV1

[. . . ] Should this happen, switch off the breaker used for your air conditioner and contact your installation specialist. N Make sure that the unit is correctly ventilated at all times: Do not place clothing or other materials over it. N If the wireless remote control will not be used for a long time, remove the batteries. (If applicable) N When using a wireless remote control, the distance should not be more than 7m from the air conditioner. [. . . ] For more detailed information, see the Installation Manual. Protections enabled by the Unit control system Type of protection Protection against cold air Defrost cycle Anti-frost protection of internal battery Delayed start of compressor CAUTION Description The internal fan is off The internal fan is off The compressor is off The start of the compressor is delayed. Operation Heating on heat pump Heating on heat pump Cooling During operation Cooling or heating on heat pump At start-up or during the selection of the operating mode When it enables During operation During operation If the air conditioner is operating in heat pump mode, it performs several defrost cycles in order to remove the frost that may have deposited on the outdoor unit (at low temperatures). In this case, the internal fan is switched off automatically and restarted only after the defrost cycle is completed. Wireless Remote Controller - Buttons and Display To use the wireless remote controller, refer to an appropriate manual. Operating mode Temperature setting Mode selection button Temperature adjustment buttons Filter Reset button Fan speed Air flow direction On Timer setting Off Timer setting Battery discharge indicator Fan speed adjustment button Swing button On Timer button Off Timer button On/Off & Timer Set/Cancel button Note After cleaning the air filter, press the button. E-6 Heat Pump Models(MR-BH01) Battery life indicator Filter reset indicator Remote control transmission indicator Airflow indicator Operating mode indicator Fan speed indicator Temperature setting On Timer indicator Off Timer indicator Power (On/Off) button Fan speed adjustment buttons Temperature adjustment buttons Mode selection button (Auto, Cool, Dry, Fan, Heat) On Timer button Off Timer button Airflow swing button (Except Duct type) Filter Reset button Timer set button Timer cancel button Time adjustment button Note Press button after cleaning the air filter. The remote control will display the filter sign to alert the user to clean the filter and turn off the display when button is pressed. Therefore, the function is not operated even if you press the swing button. Duct type air conditioner does not have function of adjusting air flow direction. E-7 ENGLISH Centralized Controller The centralized controller is an optional accessory and it is installed on the wall. To use the centralized controller, refer to an appropriate manual. Front View Operating lamp All On button All Off button On/Off indicators On/Off buttons Index Note The operating lamp comes on even when only one air conditioner connected to the centralized controller is operating. Side View Operating Mode Switch COOL AUTO HEAT Note Choose the appropriate operating mode with the Operating Mode Switch that enables the user to choose between the Cool/Auto/Heat mode. E-8 Wired Remote Controller - Buttons and Display ENGLISH Temperature setting Fan speed Air flow direction Filter Sign indicator On/Off button Temperature adjustment buttons On Timer button Timer Set/Cancel button Test button On/Off indicator Fan speed adjustment button Swing button (Not operated) Filter Reset button E-9 The wired remote controller is an optional accessory and it is installed on the wall. To use the wired remote controller, refer to an appropriate manual. Operating mode Removing frost indicator Centralized controller indicator (In case of installing the Centralized controller) Communication error indicator On Timer setting Off Timer setting Test indicator Mode selection button Note N The button is for your installation specialist. N After cleaning the air filter, press the button. Then the wired remote controller will display the FILTER SIGN indicator when the time to clean the air filter; refer to page 13. Function Controller The function controller is an optional accessory and it is installed on the wall. The function controller is an additional controller which is used with the centralized controller. To use the function controller, refer to an appropriate manual. Operating mode Removing frost indicator Centralized controller indicator Communication error indicator Room number display Temperature setting Fan speed Air flow direction Filter Sign indicator On/Off & Timer Set/Cancel button On/Off indicator Fan speed adjustment button Swing button Test indicator Temperature adjustment buttons Indoor unit selection button Test button Filter Reset button Mode selection button Note The button is for your installation specialist. After cleaning the air filter, press the button. Then the wired remote controller will display the FILTER SIGN indicator when the time to clean the air filter. E-10 Adjusting the Air Flow Direction ENGLISH E-11 There are two sets of inner air flow blades. Just as the outer air flow blade can be adjusted vertically, the inner blades can be adjusted horizontally. Adjust each set of inner blades to the required position, by pushing or pulling them sideways. Operating Recommendations Here are a few recommendations that you should follow when operating your air conditioner. Topic Heating performances Recommendation The heat pump function of the air conditioner absorbs heat from outside air and brings it indoors. As the temperature of the outside air drops, the heating performance of air conditioner will decrease. If you find that the room is not warm enough, using an additional heating appliance is recommended. When outside temperature is low but humidity is high, frost may form on the outdoor unit at HEAT mode. If this happens: The heating operation stops. The defrost mode will be triggered automatically for 3 to 14 minutes. No intervention is required ; after about 7 minutes, the air conditioner operates again normally. [. . . ] N If there is a strong light around the air conditioner, a three-wavelength light, a neon sign, etc. , for example, the air conditioner may not be operated with a remote controller. If this happens, use the remote controller close by the remote control sensor. The air conditioner does not cool or heat N Check that the correct operating mode has been selected. N The room temperature may be too low or too high. [. . . ]