User manual SAMSUNG FX 500

[. . . ] If you have any questions about your telephone line, such as how many pieces of equipment you can connect to it, telephone company will provide this information upon request. In certain circumstances, it may be necessary for the telephone company to request information from you concerning the equipment which you have connected to your telephone line. Upon request of the telephone company, provide the FCC registration number the Ringer and Number (REN) of the Equivalence equipment which is connected to your line; both of these items are listed on the equipment label and in the Service Information chapter of this guide. The sum of all of the RENs on your telephone line should be less than five in order to assure proper service from the telephone company. [. . . ] Hint : You can stop a document that you are currently sending if you do not want to send the document. The unit continues sending and the window displays [IN USE !PRESS "STOP" TO CANCEL] to alert you that the unit is in use. To stop sending document, press [STOP] again. Important Sending Facts Memory Dialing If you have stored frequently used numbers in the unit's memory, and if the remote party you are calling is set to receive documents automatically, you can send a document at the touch of a key or using [SPEED] key and 2-digit number. For information on storing numbers for memory dialing, see "Storing One-Touch & Speed Dial Numbers" on page 28. To send document using memory dialing ; 1. Load the document face down into the unit (see page 22). To dial the number assigned to onetouch key, press the one-touch key. If fax number is not assigned, the unit will automatically dial the telephone number stored in the one-touch location. To dial the number assigned to 2-digit number, press [SPEED] and enter the 2-digit number (01 - 20). The unit automatically dials the number, confirms the connection and sends the document. [SEND] means you are the indicates sending, [G3] communications standard observed by both fax machines, [9. 6] indicates the transmission speed (9600 bps), and the number following [P:] is the number of the page being received. If a fax transmission fails or the unit detects a problem, it may display an error message in the window. Refer to "Error Messages" on page 43 to clear the problem and try to send the document again. Wait until the white roller in the unit stops moving. You can then remove the jammed document without damaging your unit. [DOCUMENT JAM] message disappears and the unit returns to the standby mode. If the roller doesn't stop moving, lift the edge of the document and pull it in the direction of arrow. Clearing Document Jams If the fax unit starts to read the document and for some reasons, stops without reading all of it, the document might be jammed. DO NOT pull it out of the loading slot. Important Sending Facts Voice Request If you are sending a document and want to speak to the remote party ; 1. The V. REQUEST indicator lights to confirm your request. But your request will not go through until the unit finishes sending the last document. When sending is finished, the call signal is sent to the remote party's unit. The remote party may pick up the handset within 15 seconds if they wish to speak. If no one answers the request within 15 seconds, the signal ends. [. . . ] Contact your dealer. Maintenance and Troubleshooting How a Fax Works Facsimile is a system of sending printed or other graphic information from one location to another by producing a copy or "facsimile" of that information at the remote location. A fax unit transmits audio tones over the same telephone lines you use for person-to-person conversation. The facsimile process involves three basic steps : 1. Reading and converting the document into electronic signals (audio tones). [. . . ]