User manual SAMSUNG HL-T4675S

[. . . ] While using the on-screen menus, press the ENTER to activate (or change) a particular item. MTS (Multichannel Television Stereo) Press to choose Stereo, Mono or SAP (Separate Audio Program). ADD/DEL Press to add or erase channels in the TV's memory. Use the ADD/DEL button to memorize and erase the fine tuning after fine tuning channels. [. . . ] If you have a mono VCR, connect L/Mono to VCR Audio OUT using only one audio cable. If you have a S-VHS VCR, use the S-Video connections and remove the video cable. Do not connect the video cable and the S-Video cable to video1 simultaneously. When you use a converter box with your TV there may be features that you can not program using the remote control, such as programming your favorite channels and blocking channels. Second VCR Connecting a DVD Player The rear panel jacks on your TV make it easy to connect a DVD player to your TV. Connecting to Y, PB, PR Connect a set of audio cables between the COMPONENT (1 or 2) audio (L, R) in jacks on the TV and the AUDIO OUT jacks on the DVD player. To enable Component video viewing, connect a set of video cables between the COMPONENT (1 or 2) VIDEO (Y, PB, PR) in jacks on the TV and VIDEO (Y/PB/PR or Y/CB/CR) OUT jacks on the DVD player. TV Rear Panel Connecting to Audio and Video Jacks Connect a set of audio cables between the Audio in (1 or 2) jacks on the TV and the AUDIO OUT jacks on the DVD player. Connect a video cable between the VIDEO IN (1 or 2) jack on the TV and the VIDEO OUT jack on the DVD player. Operation Selecting the Video Signal Source Before your TV can begin memorizing the available channels, you must specify the type of signal source that is connected to the TV (i. e. , an antenna or a cable system). or button to select "Channel", then press the ENTER button. or button to select "Air/CATV", then press the ENTER button. If you are connected to an antenna, press the . . . or button to select the type of cable system: "STD", "HRC" or "IRC". Please don't touch the front glass of a new lamp or the glass of the lamp container. If a new lamp is improperly handled, the quality of the screen image can be affected and the expected life span of the lamp can be reduced. Be sure to tighten the lamp cover on the TV after changing the lamp. Note that the TV will not function if the lamp cover is not securely attached. Please tighten the holding screw on the lamp cover after it has been attached to the TV. · · : Light is On, : Light is Blinking, : Light is Off Front Panel LED Indicators TIMER LAMP STAND BY/TEMP Standby state. The picture will automatically appear in about 15 seconds. Auto Timer ON/OFF has been set and the set will automatically be turned on in about 25 seconds. A cooling fan inside the set is not operating normally. Lamp cover on rear of the set is not properly shut. Check if the ventilation hole on the rear of the set is blocked, because if the inner temperature is too high, the power will shut off. [. . . ] All projection TV use sun screen separately to prevent the screen from reflection. But, DLP does not use sun screen and white spot may appear. When you install your TV, light should not shine directly on screen. This phenomenon does not appear while TV is turned on and doe not have any effects on picture quality. [. . . ]