User manual SAMSUNG HW-D450

[. . . ] HW-D450 HW-D451 Crystal Surround Air Track (Active Speaker System) user manual imagine the possibilities Thank you for purchasing this Samsung product. To receive more complete service, please register your product at www. samsung. com/register features Active Speaker System This unit features an Active Speaker System that provides high sound quality in a single slim unit. This unit does not require any satellite loudspeakers or speaker cabling, which are normally associated with conventional surround sound systems. Multi-function Remote Control The supplied remote control can be used to control the TV connected to this unit. The remote control has a TV hotkey that enables you to perform various operations with the simple press of a button. Special Sound mode You can select from 7 different sound modes (MUSIC, NEWS, DRAMA, CINEMA, SPORTS, GAME, PASS (Original Sound)) depending on the type of content you want to enjoy. Compatibility with various audio Technologies This unit employs decoders compatible with Dolby Digital and DTS (Digital Theater Systems). - DolbyDigital This is the standard audio signal format used on DVDs and other purely digital media. [. . . ] If the main unit doesn't make wireless connection, follow steps 1-4 above to retry the connection between the main unit and wireless subwoofer. AH59-02330A The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture. For optimal listening performance, make sure that the area around the wireless subwoofer location is clear of any obstructions. 1 aTTaCHInG THE TOROIDaL FERRITE CORE TO THE POWER CORD OF THE SubWOOFER If you attach a Toroidal ferrite core to the power cord of the Subwoofer, it will help to prevent RF interference from radio signals. Pull the fixing tab of the Toroidal ferrite core to open it. Make three loops in the power cable of the subwoofer. EnG COnnECTIOnS 3. Attach the Toroidal ferrite core to the Subwoofer power cord as the figure shows and press it until it clicks. InSTaLLInG TOROIDaL FERRITE TO SubWOOFER Lift up to release the lock and open the core. Close the lock back. Make two rounds on the coil with the power cable. (Start winding at 5-10cm away from the switch) InSTaLLInG FERRITE CORE TO auDIO CabLE Lift up to release the lock and open the core. Close the lock back. Place the audio cable on the opened core. 1 USEiPod/iPhoneWiTHAWiRElESSDOcKcRADlEFORiPod/iPhone (SoldSeparately(HT-WDc10)) You can enjoy finer quality of music through the speaker by sending iPod/iPhone's audio signal using a Wireless Transmitter. To link the main unit with wireless transmitter, you have to make ID setting when both main unit and wireless transmitter are turned on. Turn on the main unit and connect the iPod/iPhone to the Wireless transmitter. Then press inpuT SeleCT button on the remote control to select "W iPod" mode. The inpuT SeleCT mode of the main unit will switches as follows. Repeatedly press DIGI. 1 DIGI. 2 ANALOG W iPod ( See page 18 ) The Sound bar will not be turned off if iPod/iPhone is not connected to the Wireless Transmitter. For more information on HT-WDC10, refer to the HT-WDC10's user manual. HOWTOlinKTHEWiRElESSTRAnSMiTTERWiTHTHEMAinUniT Set an ID of the Subwoofer before setting a Transmitter ID. Turn off your Home Theater (HW-D450, HW-D451). Press the hold "3DSOUnD" button on the remote control for 5 seconds. The standby light on the HW-D450, HW-D451 will blink once. Connect the iPod/iPhone to the Wireless transmitter. Press the "iDSET" button on the back of the Wireless transmitter for 5 seconds. The link light on the wireless transmitter will blink fast. Turn on your Home Theater(make sure the wireless transmitter's Link LED in ON). To listen to music from your iPod/iPhone over the Home Theater, select the iPod mode as the Home Theater's source. · You can control the speaker volume of iPod/iPhone with a volume wheel or a volume bar. · When iPod/iPhone is stopped or in a power saving mode, a Wireless transmitter is turned to the Sleep Mode. [. . . ] (SAMSUNG) and delivered new, in the original carton to the original consumer purchaser, is warranted by SAMSUNG against manufacturing defects in materials and workmanship for a limited warranty period of: One(1)yearPartsandlabor* (*90DaysPartsandlaborforcommercialUse) This limited warranty begins on the original date of purchase, and is valid only on products purchased and used in the United States. To receive warranty service, the purchaser must contact SAMSUNG for problem determination and service procedures. Warranty service can only be performed by a SAMSUNG authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to SAMSUNG or SAMSUNG's authorized service center. [. . . ]