User manual SAMSUNG LE32A330J1N

[. . . ] Contact SAMSUNG WORLDWIDE If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care centre. Thank you for purchasing this Samsung product. To receive more complete service, please register your product at Contact SAMSUNG WORLDWIDE If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care centre. (See back cover for more information) Precautions When Displaying a Still Image A still image may cause permanent damage to the TV screen. [. . . ] Channel names will be assigned automatically when channel information is broadcast. These names can be changed, allowing you to assign new names. If necessary, select the channel to be assigned to a new name by pressing the or button. Select a letter, number or symbol Move on the next letter Move back the previous letter Confirm the name then. The following characters are available: Letters of the alphabet (A~Z) / Numbers (0~9) / Special characters (+, -, *, /, space) Repeat steps to for each channel to be assigned to a new name. Use the number buttons to directly select the channel that you want to fine tune. Fine tuned channels that have been saved are marked with an asterisk "*" on the right-hand side of the channel number in the channel banner. Size: Auto Wide/1:9/Wide Zoom/Zoom/:/Just Scan You can select the picture size which best corresponds to your viewing requirements. Wide Zoom: Magnify the size of the picture more than 4:3. Zoom: Magnifies the 16:9 wide picture (in the vertical direction) to fit the screen size. :: This is the default setting for a video movie or normal broadcasting. Just Scan: Use the function to see the full image without any cutoff when HDMI (720p/1080i) or Component (1080i) signals are input. In PC Mode, only "16:9" and "4:3" mode can be adjusted. Settings can be adjusted and stored for each external device you have connected to an input of the TV. Temporary image retention may occur when viewing a static image on the set for more than two hours. When Double ( , ) mode has been set in PIP, the Picture Size cannot be set. Wide Zoom: Move the screen up/down using the or button after selecting the by pressing the or ENtER button. zoom: Select by pressing the or button. TOOLS Use the or button to move the picture up and down. After selecting , use the or button to magnify or reduce the picture size in the vertical direction. after selecting "Just Scan" in hDMI (100i) or Component (100i) mode: Select by pressing the or button. Use the , , or button to move the picture. [. . . ] The location of the Kensington Lock may be different depending on its model. Check that the mains lead has been connected to a wall socket. Check that you have pressed the button on your set. Screen is black and power On your computer check; Power, Signal Cable. [. . . ]