User manual SAMSUNG LE37C580 POWER CONSUMPTION GUIDE

[. . . ] To avoid such image retention, reduce the degree of brightness and contrast of the screen when displaying a still image. · Watching the LCD TV in 4:3 format for a long period of time may leave traces of borders displayed on the left, right and center of the screen caused by the difference of light emission on the screen. Playing a DVD or a game console may cause a similar effect to the screen. Damages caused by the above effect are not covered by the Warranty. [. . . ] Zoom: Magnifies the 16:9 wide picture (in the vertical direction) to fit the screen size. :: This is the default setting for a video movie or normal broadcasting. Just Scan: Use the function to see the full image without any cutoff when HDMI (720p/1080i) or Component (1080i) signals are input. "Auto Wide" function is available only in "TV", "Ext. 1", "Ext. 2", "AV", and "S-Video" mode. In PC Mode, only "16:9" and "4:3" mode can be adjusted. Settings can be adjusted and stored for each external device you have connected to an input of the TV. Temporary image retention may occur when viewing a static image on the set for more than two hours. "Wide Zoom": Press the button to Select "Position", then press the ENTER button. Press the or button to move the screen up/down. "Zoom": Press the button to Select "Position", then press the ENTER button. Press the or button to move the picture up and down. Press the button to Select "Size", then press the ENTER button. New image compensation Algorithm gives brighter, clearer, more detailed image to you. DNIeTM technology will fit every signal into your eyes. This function is not available in "Movie" and "Standard" mode. HDMI Black Level: Normal/Low You can directly select the black level on the screen to adjust the screen depth. This function is active only when the external input connects to HDMI (RGB signals). Blue Only Mode: Off/On This function is for AV device measurement experts. This function displays the blue signal only by removing the red and green signals from the video signal so as to provide a Blue Filter effect that is used to adjust the Colour and Tint of video equipment such as DVD players, Home Theaters, etc. Using this function, you can adjust the Colour and Tint to preferred values appropriate to the signal level of each video device using the Red/Green/Blue/ Cyan/Magenta/Yellow Colour Bar Patterns, without using an additional Blue Filter. "Blue Only Mode" is available when the picture mode is set to "Movie" or "Standard". English - 0 Resetting the Picture Settings to the Factory Defaults 1. To select the desired picture mode, follow the "Changing the Picture Standard" instructions numbers 1 and 2. (see page 27) Press the or button to select "Picture Reset", then press the ENTER button. Detailed Settings Picture Options Picture PictureReset 3. Press the or button to select "Reset Picture Mode" or "Cancel", then press the ENTER button. [. . . ] If you have any doubt about the security of your connections, contact a professional installer. Wall 4. English - Troubleshooting: Before Contacting Service Personnel No sound or picture · · · · Check that the mains lead has been connected to a wall socket. Check that you have pressed the button on your set. Check the picture contrast and brightness settings. Check the volume. Normal picture but no sound · Check the volume. [. . . ]