User manual SAMSUNG LN-R408 QUICK START

[. . . ] Connect an RF cable between the ANT OUT terminal on the VCR and the ANT1 IN (CABLE) or ANT 2 IN (AIR) terminal on the TV. Connect a video cable between the VIDEO OUT jack on the VCR and the AV IN [VIDEO] jack on the TV. [. . . ] buttons to select "STD", "HRC" or "IRC", press the ENTER Press the UP/DOWN buttons to select "Analog Channel", then press the ENTER button. Press the UP/DOWN buttons to select "STD", "HRC" or "IRC", press the ENTER button. Press the UP/DOWN buttons to select "Start", then press the ENTER button to memorize the channels. BN68-00515U-X0Eng. qxd 1/5/05 10:01 PM Page 7 5 The TV will begin memorizing all of the available channels. After all the available channels are stored, the Auto program menu reappears. Press the ENTER button when channel memorization is complete. "Set to daylight savings time. " menu is auto matically displayed. 6 Press the ENTER button. Press the UP/DOWN buttons to select "Yes" or "No", then the ENTER button. "Select your time zone in which you live" menu is automatically displayed. 7 Press the UP/DOWN buttons to highlight the time zone for your local area (and to move the highlight to the appropriate time zone on the map of the United States). Press the ENTER button. If you have received a digital signal, the time will be set automatically. If not, see page 70 to set the clock. 8 The message "Completed. Time will be updated automatically. " is displayed. When you have finished, press the ENTER button. BN68-00515U-X0Eng. qxd 1/5/05 10:01 PM Page 8 Setting the Function Help Displays help on the menu functions. 1 Press the MENU button to display the menu. Press the UP/DOWN buttons to select "Setup", then press the ENTER button. 2 Press the UP/DOWN buttons to select "Function Help:, then press the ENTER button. 3 Press the UP/DOWN buttons to select "On", then press the ENTER button. To Select the Source Press the SOURCE button on the remote control You can select the TV mode or an input source (AV, S-Video, Component 1, Component 2, PC, HDMI) connected to the TV set. Use this button to choose an input source that you would like to watch. BN68-00515U-X0Eng. qxd 1/5/05 10:01 PM Page 9 Remote control Functions Chart POWER Turns the TV on and off. PRE-CH Tunes to the previous channel. ANTENNA Press to select "AIR" or "CABLE". CH and CH (Channel UP/Down) Press CH or CH change channels. to GUIDE Press to display he on-screen Electronic Program Guide (EPG). VOL + and VOL Press to increase or decrease the volume. Press to select additional channels (digital and analog) being broadcast by the same station. [. . . ] adjusted on the output source Check the antenna connections. STB) with a digital signal. Poor picture Try another channel. [. . . ]