User manual SAMSUNG LN32A610A1R

[. . . ] Connect Audio Cables(Not supplied) between the DVI IN (HDMI 2) [R-AUDIO-L] jack on the TV and the Cable Box/Satellite receiver (Set-Top Box). N When using an HDMI/DVI cable(Not supplied) connection, you must use the HDMI IN2 jack. English - 2 CONNECTINg A CABLE BOX/SATELLITE RECEIVER (SET-TOP BOX) VIA COMPONENT CABLES CABLE BOX/SATELLITE RECEIVER (SET-TOP BOX) REAR PANEL TV REAR PANEL 2 . 2. Connect a Component Cable(Not supplied) between the COMPONENT IN ( or 2) [Y, PB, PR ] jacks on the TV and the COMPONENT jacks on the Cable Box/Satellite receiver (Set-Top Box). Connect Audio Cables(Not supplied) between the COMPONENT IN ( or 2) [R-AUDIO-L] jacks on the TV and the AUDIO OUT jacks on the Cable Box/Satellite receiver (Set-Top Box). English - 3 Memorizing the Channels Selecting the Video Signal-source Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the TV (i. e. [. . . ] an Air or a Cable system). TV Your TV can memorize and store all of the available channels for both "off-air" (Air) and "Cable" channels. After the available channels are memorized, use the CH or CH button to scan through the channels. This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and adding or deleting channels (Channel Manager). Channel Air / Cable : Air Auto Program Channel Manager Fine Tune Color System : Auto . 2. Press the MENU button to display the menu. Press the or button to select "Channel", then press the ENTER button. Move Enter Return Press the ENTER button. Repeatedly press the or button to cycle through these choices: "Air", "STD", "HRC", or "IRC" (all cable TV) Press the ENTER button to select. · Check the transmitting signal of the corresponding cable TV network or broadcasting station. The picture on the TV screen is broken intermittently (a mosaic or distorted). · Check the transmitting signal of the corresponding cable TV network or broadcasting station. · If you are using a publically shared antenna, check the signal by asking your apartment manager. · Replace the battery and then retry. · Press the TV button on the remote control to select TV mode. · Some noise can be heard due to the characteristics of the product. I cannot control the TV using the remote control. · When the battery is flat. [. . . ] · Press the TV button on the remote control to select TV mode. · Some noise can be heard due to the characteristics of the product. I cannot control the TV using the remote control. · When the battery is flat. · When the remote control malfunctions temporarily. [. . . ]