User manual SAMSUNG LT17E24C OPEN SOURCE GUIDE (VER.1.1)

[. . . ] Use a screwdriver to tighten the screws. Press the [. . . /] buttons to move to <Channel>, then press the [ENTER] button. The <Channel> menu will be displayed. Move Enter Return Press the [. . . /] buttons to move to <Air/CATV>, then press the [ENTER] button. The signal source menu will be displayed. Channel Note Press the [. . . /] buttons to move to signal source of your choice, then press the [ENTER] button. [. . . ] Press the [EXIT] button to finish. Air Air/CATV : Air STD Auto Program HRC Add/Delete IRC Fine Tune LNA : On STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area. At this point the signal source has been selected. Proceed to "Storing Channels Automatically" (next page). 1 2 Plug the adaptor into the VHF/UHF terminal on the bottom of the back panel. Move Enter Return Antennas with 75-ohm Round Leads If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300-ohm twin flat leads, follow the directions below. Storing Channels Automatically The AUTO PROGRAM feature automatically stores all of the available Air/CATV channels in the memory. In a moment the Language menu will be displayed. Language English Français Español Português Move Enter Skip Connect the other end of this cable to the VHF/UHF antenna terminal on the back of the TV. Connecting to a Cable Box that Descrambles Some Channels If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-way splitter, an RF (A/B) switch and four lengths of coaxial cable. (These items are available at most electronics stores. ) 1 2 3 Plug & Play Plug & Play Press the [. . . /] buttons to move to language of your choice, then press the [ENTER] button. The signal source setup menu will be displayed after a moment. 1 2 3 4 Find and disconnect the cable that is connected to the ANTENNA IN terminal on your cable box. This terminal might be labeled "ANT IN" "VHF IN" or simply, "IN" , . Plug & Play Press the [. . . /] buttons to move to signal source of your choice: <Air, STD, HRD and IRC>, then press the [ENTER] button. The <Auto Program> menu will be displayed after a moment. Air/CATV Air STD HRC IRC Move Enter Skip Auto Program Connect this cable to a two-way splitter. Incoming Cable Splitter Press the [ENTER] button then select <START>. Air 13 Start Enter Skip 4 5 6 Connect a coaxial cable between an OUTPUT terminal on the splitter and the IN terminal on the cable box. The TV will begin memorizing all of the available channels. To stop, press the [ENTER] button again. [. . . ] To stop, press the [ENTER] button again. [. . . ]