User manual SAMSUNG LW17N13WX/XEU

[. . . ] - If you wish to connect both the Set-Top Box and VCR (or DVD), you should connect the Set-Top Box to the VCR (or DVD) and connect the VCR (or DVD) to your set. Connecting a Computer - Connect the 24 Pin DVI connector to the PC video connector. [. . . ] Connecting a Computer - Connect the 24 Pin DVI connector to the PC video connector. - Connect the stereo audio cable to the "Audio (ST)" jack on the rear of your set and the other end to the "Audio Out" jack of the sound card on your computer. 24 Pin DVI connector Pin Descrizione Pin Descrizione 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Rx 2Rx 2+ Grounding No connection No connection DDC Clock (SCL) DDC Data (SDA) Analog Vertical Sync Rx 1Rx 1+ Grounding No connection No connection DDC Input Power (+5V) Self-Raster 16 17 18 19 20 21 22 23 24 25(C3) 26(C5) 27(C4) 28(C2) 29(C5) 30(C1) Output Signal Connection Rx 0Rx 0+ Grounding No connection No connection Grounding Rx CRx C+ Analog (Blue) Analog Grounding Analog Horizontal sync. Analog (Green) Analog Grounding Analog (Red) English-2 01-BN68-00574C-00Eng. qxd 2/11/04 8:24 AM Page 7 Viewing the Connection Panel Connecting a DVD Player or Set-Top Box to the TV with a DVI-D Cable - Connect a DVI-D cable between the DVI-I INPUT connector on the TV and the DVI connector on the DVD player/Set-Top BOX. - Connect a set of audio cables between the PC AUDIO INPUT jack on the TV and the AUDIO OUTPUT jacks on the DVD player/ Set-Top BOX. If you are using a DVI-D cable to connect Be sure to connect the audio cable (sold separately) as shown above to get normal TV sound. Kensington Slot - This television has been designed to apply a burglarproof lock. Retractable Stand Tilt the screen until you feel comfortable. The maximum tilt angle is 7 degrees in the backward direction. Please do not tilt the television beyond the specified range. Using excessive force to tilt the television beyond the specified range may cause permanent damage to the mechanical part of the stand. English-3 04-BN68-00574C-00Eng. qxd 2/17/04 2:43 AM Page 61 How to connect the cables and stand base 1 Remove the cover as shown in the picture. 2 Connect the cables as shown in the picture. 3 Replace the cover. Attach the stand to the TV set as shown in the picture. Note : The curved side of the stand base should be placed at the back of the TV set as shown in the above figure. 4 Do NOT lift the TV set by the stand. [. . . ] Please do not tilt the television beyond the specified range. Using excessive force to tilt the television beyond the specified range may cause permanent damage to the mechanical part of the stand. English-3 04-BN68-00574C-00Eng. qxd 2/17/04 2:43 AM Page 61 How to connect the cables and stand base 1 Remove the cover as shown in the picture. 2 Connect the cables as shown in the picture. 3 Replace the cover. Attach the stand to the TV set as shown in the picture. [. . . ]