User manual SAMSUNG MAX-900

[. . . ] THREE-CD CHANGER MINI-COMPACT SYSTEM MAX-900 Instruction Manual POWER TIMER ON/OFF TIMER CLOCK PRESET EQ S. BASS MUTE FUNCTION SLEEP PROGRAM MONO/ST /SET TUNER CD REPEAT CLOSE DISC SKIP OPEN/ BAND +10 CD VOL. CD TUNING MODE CD VOL. Safety Warnings GB Contents Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION-INVISIBLE LASER RADIATION WHEN OPEN AND INTER LOCKS DEFEATED, AVOID EXPOSURE TO BEAM. This symbol indicates that dangerous voltage which can cause electric shock is present inside this unit. This symbol alerts you to important operating and maintenance instructions accompanying the unit. [. . . ] It returns to its original position automatically when the function is completed or you cancel the command. Always treat your cassettes with care; refer, if necessary, to the section entitled "Precautions When Using Audio Cassettes" on page 19. Listening to Two Cassettes in Sequence You can only listen to one cassette at a time but you can switch automatically from one deck to the other to listen to two cassettes, one after the other. Recording a Radio Programme You can record a radio programme of your choice. You can only record on cassettes in Deck 1. You can only record on normal bias cassettes. You do not need to adjust the volume, as it has no effect on recording. Copying a Cassette (Dubbing) GB You can copy a cassette from Deck 2 to Deck 1. Two options are available: Normal speed dubbing High-speed dubbing Take care not to insert the tape to be copied in Deck 1, as it will be erased when you start recording. You do not need to adjust the volume, as it has no effect on the recording. 1 2 3 4 5 6 7 8 9 Switch the system on by pressing the POWER button. To open either Deck 1 or 2, press the corresponding STOP/EJECT ( button. ) 1 2 3 Repeat Steps 1 to 5 above, inserting a cassette in each deck. Press the PLAY ( ) button corresponding to Deck 2. Press the PLAY ( ) and PAUSE ( ) at the same time for Deck 1. Result: The cassette in Deck 2 is played until the end of the tape is reached; the cassette in Deck 1 then starts playing automatically. 1 2 3 4 5 6 Switch your system on by pressing POWER. Press the TUNER button to select the radio function. Select the radio station that you wish to record. Press the RECORD ( ) button corresponding to Deck 1. Press STOP/EJECT ( ) when you are ready to stop recording. Insert the pre-recorded cassette with the open edge of the tape facing downwards. Close the deck by pushing on it until it clicks into place. You can press PAUSE ( ) during recording, if you wish to skip unwanted passages. Press PAUSE ( ) again when you want to start recording again. 3 Press the PLAY ( ) button corresponding to the selected deck to start listening to the cassette. Adjust the volume by pressing the appropriate VOLUME buttons. 3 2 POWER ON/STANDBY 1 R 1 2 3 4 5 6 7 8 Switch your system on by pressing POWER. Press the TAPE button to select the cassette function. Press RECORD ( Press PLAY ( ) for Deck 1. ) for Deck 2. To copy a cassette at high speed, press Hi-DUBBING. Result: The cassette is copied and the H DUBB indicator flashes. When you have finished recording, press the STOP/EJECT ( buttons for both Deck 1 and Deck 2. [. . . ] Moisture entering the unit could lead to dangerous electric shock and can cause equipment damage. In such events immediately disconnect the main plug from the socket. During thunderstorms, disconnect the main plug from the socket. Main voltage peaks due to lightning could damage the unit. G E N E R A L There is no sound The Timer does not work 3 POWER ON/STANDBY The compact disc player does not start playing C D R VOLUME VOLUME UP DEMO 1 DISC SELECTOR 2 3 DISC CHANGE POP OPEN / CLOSE TUNER BAND CD TAPE AUX AUX PO W ER SO U ND PROGRAM/SET MONO/ST TIMER/CLOCK TIMER ON/OFF DOWN S. BASS CLASSIC 1 2 Connecting Headphones You can connect a set of headphones to your mini-compact system so that you can listen to music or radio programmes without disturbing other people in the room. The earphones must have a 6. 3 mm jack or an appropriate adapter. [. . . ]