User manual SAMSUNG MAX-KDZ155

[. . . ] DVD KARAOKE MINI COMPONENT SYSTEM DVD-OK/DVD/VCD/MP3-CD/CD CD-R/RW PLAYBACK MAX-KDZ150 Instruction Manual Safety Warnings GB CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT PRODUCTO LASER CLASE 1 Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION-INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKS DEFEATED, AVOID EXPOSURE TO BEAM. This symbol indicates that dangerous voltage which can cause electric shock is present inside this unit. This symbol alerts you to important operating and maintenance instructions accompanying the unit. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. [. . . ] PRO-Logic is selected, and the playback sound has the Dolby Surround effect. To cancel Dolby Surround mode Press the Dolby Surround button repeatedly until PASS is displayed. 1 2 Press the Dolby Surround button. Result: " PRO-LOGIC" appears on the displayed. 7 8 9 Program SET Press the Test Tone button. A noise signal is sent to each channel in turn in the following sequence. Dolby Surround 0 EQ Cancel/Clear MO/ST L DVD-OK/DVD/TUNER CNTR R REAR (L : Left Speaker, CNTR : Center Speaker, R : Right Speaker, REAR : Rear Speaker) When playing DVD, if an Audio is Dolby Digital(multi-channel), it can not be operated. When being connected to headphones and microphone, this function cannot be operated. 3 4 Press the Test Tone button again to stop the noise signal. To change the sound levels or delay time after adjusting the balance with the noise sequencer. While L, R, CNTR, REAR is displayed, press the UP/DOWN Additional Dolby Surround modes In addition to the PRO-Logic mode, this unit is also equipped with the 3 STEREO modes. PRO-Logic : Use this mode when rear speakers are connected. The center channel signals are output through the left and right speakers. 3 STEREO : Use this mode when no rear speakers are connected. This mode reproduces rear sounds through the front speakers. PRO-Logic 3 STEREO PASS ( / ) button to adjust the level: L 0~-9, R 0~-9, CNTR -6~6, REAR -6~6. While CNTR, REAR, DELAY TIME is displayed, press the UP/DOWN ( / ) button. ­ CNTR : Large/Small/None ­ REAR : USE/None ­ DELAY TIME : 15/20/25/30 mS When the Dolby surround system is on, this function can be operated. SET Dolby Surround 0 EQ Cancel/Clear MO/ST Depending on the sound source or listening conditions, a surround effect may not be obtained even when the Dolby Surround is on. The full Dolby Surround effect cannot be obtained when using softDOLBY SURROUND ware without mark. In this case, use the DSP system instead. P R O L O G I C 1 Down DVD-OK/DVD/TUNER Tuning Up 1 2 3 Mute 4 Enter 4 5 6 Search Song 7 8 9 Program SET Dolby Surround 0 EQ Cancel/Clear MO/ST 4 + Volume TAPE DVD-OK/DVD/TUNER Down Tuning Up Tuner Band Male/Female Sound Edit Step 4 SPK Edit Sleep Hi-Light Score 4Test Tone Melody 2, 3 Repeat Fanfare Key Control b Enter Tempo + Volume TAPE 25 Dolby Surround (Cont'd) To set the delay time When 5. 1 Channel Surround Sound is played, you can enjoy the best sound if the distance between you and each speaker is the same. You can set Delay Time in the Center/Rear Speaker to customize the sound to the acoustics of your room. Setting Center Speaker If the distance of Dc is equal to or longer than the distance of Df in the figure, set the mode as 0ms. Otherwise, change the setting according to the table on the table. Setting Rear Speakers If the distance of Df is equal to the distance of Ds in the figure, set the mode as 0ms. Otherwise, change the setting according to the table. Dolby Surround (Cont'd) GB Speaker Setting Methods c Key Reset Numeri Counter 1/2 Deck Select Reverse Song Dubbin g Mo de P Title/Tr ack Title/T Tuning Mode (A)=Df-Dc Distance of (A) 50 100 400 200 Value(ms) 1. 3 2. 6 3. 9 5. 3 Front/Woofer Speakers (B)=Df-Ds Distance of (B) 200 400 600 Value(ms) 5. 3 10. 6 15. 9 Set the front speakers so that their tweeters (high-range) are aligned at about ear level and at a horizontal angle of 45° to the prime listening position. Center Speaker Ideally the center speaker should be positioned with its top surface flush with the front speakers. However, you may place the speaker either on top or near the bottom of your TV set. [. . . ] Thickness: 1. 2 mm 125 Hz ~ 12 KHz 40 dB 35 dB 60 dB 40 Watts/CH RMS, IEC (total harmonic distortion: 10 %) 80 Watts/CH RMS, IEC (total harmonic distortion: 10 %) 3 x 30 Watts RMS, IEC (total harmonic distortion: 10 %) 50 dB 75 dB 270 (W) x 332 (H) x 476 (D) mm 36 Reference Note on Terminology ANGLE CHAPTER NUMBER DVD PCM PBC (PLAYBACK CONTROL) REGION NUMBER SUBTITLES TITLE NUMBER TRACK NUMBER VIDEO CD Recorded onto some DVD discs are scenes which have been simultaneously shot from a number of different angles (the same scene is shot from the front, from the left , from the right , etc. ). With such discs, the Angle button can be used to change the angle of view for specific scenes. These numbers are recorded on DVD discs. A Title is subdivided into many sections, each of which is numbered, and specific parts of the video can be searched quickly using these numbers. [. . . ]