User manual SAMSUNG MB1765

[. . . ] SyncMaster MB1763 / MB1765 Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock When not used for extended periods of time, set your PC to DPMS. If using a screen saver, set it to the active screen mode. ? If the size of your monitor is small, or if the same image is present for long periods of time, you may see afterimages due to damage to the fluorescent substance on the inside of the CDT. Do not use a damaged or loose plug. ? This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. ? This may cause an electric shock or fire. Use only a properly grounded plug and receptacle. ? An improper ground may cause electric shock or equipment damage. Do not excessively bend the plug and wire nor place heavy objects upon them, which could cause damage. ? Failure to do so may cause an electric shock or fire. Disconnect the plug from the outlet during storms or lightening or if it is not used for a long period of time. ? Failure to do so may cause an electric shock or fire. Do not connect too many extension cords or plugs to an outlet. ? This may cause a fire. Do not cover the vents on the monitor cabinet. ? Bad ventilation may cause a breakdown or fire. Put your monitor in a location with low humidity and a minimum of dust. ? An electric shock or fire could result inside the monitor. Do not drop the monitor when moving it. ? This may cause damage to the product or human body. Place the monitor on a flat and stable surface. ? The monitor can cause injury by falling. Set down the monitor carefully. ? It could be damaged or broken. Do not place the monitor face down. ? The CDT surface may be damaged. Do not use the monitor without the monitor stand. ?? It could break down or cause a fire due to bad ventilation. If the monitor must be used without the supplied stand, take steps to insure proper ventilation. When cleaning the monitor case or the surface of the CDT, wipe with a slightly moistened, soft fabric. [. . . ] Out of Range" message comes up, disconnect the cable from the computer while the monitor is still powered on. If there is a message coming up on the screen or if the screen goes white, this means the monitor is in working condition. In this case, check the computer for trouble. ? SyncMaster MB1763 General Model Name Picture Tube Type Deflection angle Dot Pitch Screen type 17"(43cm) MagicBrightTM (40. 6cm viewable) 90 ° 0. 20mm (Horizontal) Aluminized tri-color phosphor dot trio with black matrix. Multi-layer coated with anti-static SyncMaster MB1763 Maximum Resolution 1280 Dots, 1024 Lines @65Hz Active Display Horizontal Vertical Synchronization Horizontal Vertical Input Signal Definition Video Signal Sync Signal Display Color Unlimited Maximum Pixel Clock 110 MHz Power Supply AC 90 ~ 264V, 60/50 Hz ± 3Hz Power Consumption 72W (Nominal) Dimensions (WxDxH) 398 x 412 x 400mm (with Stand) Weight 16. 0 kg Environmental considerations Operating Storage Plug and Play Capability This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings. Note: Design and specifications are subject to change without prior notice. Temperature: 32°F ~ 104°F(0°C ~ 40°C) Humidity: 10% ~ 80%, non-condensing Temperature: -4°F ~113°F (-20°C ~ 45°C) Humidity: 5% ~ 95%, non-condensing RGB, Analog 0. 7 Vpp positive at 75 ohms Separate H/V sync, TTL level, positive or negative 30 ~ 70 kHz 50 ~ 160 Hz 312 ± 4 mm 234 ± 4 mm SyncMaster MB1763 This monitor has a built-in power management system called PowerSaver. This system saves energy by switching your monitor into a low-power mode when it has not been used for a certain amount of time. The monitor automatically returns to normal operation when you move the computer's mouse or press a key on the keyboard. For energy conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for long periods. The PowerSaver system operates with a VESA DPMS compliant video card installed in your computer. Use a software utility installed on your computer to set up this feature. State Power Indicator Power Consumption Normal Operation Green 72W(Nominal) Power-off Mode EPA/ENERGY 2000 Green, Blinking Less than 2W This monitor is EPA ENERGY STAR® compliant and ENERGY2000 compliant when used with a computer equipped with VESA DPMS functionality. As an ENERGY STAR® Partner, SAMSUNG has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. SyncMaster MB1763 If the signal transferred from the computer is the same as the following Preset Timing Modes, the screen will be adjusted automatically. However, if the signal differs, the screen may go blank while the power LED is on. Refer to the video card manual and adjust the screen as follows. Preset Timing Modes Display Mode IBM, 640 x 480 IBM, 720 x 400 VESA, 640 x 480 VESA, 640 x 480 VESA, 800 x 600 VESA, 800 x 600 VESA, 1024 x 768 VESA, 1024 x 768 Horizontal Frequency (kHz) 31, 469 31, 469 37, 500 43, 269 46, 875 53, 674 60, 023 68, 677 Vertical Frequency (Hz) 59, 940 70, 087 75, 000 85, 008 75, 000 85, 061 75, 029 84, 997 Pixel Clock (MHz) 25, 175 28, 322 31, 500 36, 000 49, 500 56, 250 78, 750 94, 500 Sync Polarity (H/V) -/-/+ -/-/+/+ +/+ +/+ +/+ Horizontal Frequency The time to scan one line connecting the right edge to the left edge of the screen horizontally is called Horizontal Cycle and the inverse number of the Horizontal Cycle is called Horizontal Frequency. Unit: kHz Vertical Frequency Like a fluorescent lamp, the screen has to repeat the same image many times per second to display an image to the user. The frequency of this repetition is called Vertical Frequency or Refresh Rate. Unit: Hz SyncMaster MB1765 General Model Name Picture Tube Type Deflection angle Dot Pitch Screen type 17"(43cm) MagicBrightTM (40. 6cm viewable) 90 ° 0. 20mm (Horizontal) Aluminized tri-color phosphor dot trio with black matrix. Multi-layer coated with anti-static SyncMaster MB1765 Maximum Resolution 1600 Dots, 1200 Lines Active Display Horizontal Vertical Synchronization Horizontal Vertical Input Signal Definition Video Signal Sync Signal Display Color Unlimited Maximum Pixel Clock 185 MHz Power Supply 90 ~ 264VAC rms, 60/50 Hz ± 3Hz Power Consumption 76W (Nominal) Dimensions (WxDxH) 398 x 412 x 400mm (with Stand) Weight 16. 0 kg Environmental considerations Operating Storage Plug and Play Capability This monitor can be installed on any Plug & Play compatible system. [. . . ] Since the end of the 1980s TCO has been involved in influencing the development of IT equipment in a more user-friendly direction. Our labelling system started with displays in 1992 and is now requested by users and IT-manufacturers all over the world. For more information, please visit www. tcodevelopment. com TCO'03 Recycling Information (TCO'03 applied model only) [European Residents Only] For recycling information for TCO'03 certified monitors, for the residents in the following countries, please contact the company corresponding to your region of residence. For those who reside in other countries, please contact a nearest local Samsung dealer for recycling information for the products to be treated in environmentally acceptable way. [. . . ]