User manual SAMSUNG MH052FDEA

[. . . ] Should this happen, switch off the breaker used for your air conditioner and contact your installation specialist. x Make sure that the unit is correctly ventilated at all times: Do not place clothing or other materials over it. [. . . ] This product should not be mixed with other commercial wastes for disposal. E-3 ENGLISH View of the Unit The figures are shown in this instruction may differ from yours depending on the model. Indoor Unit Air outlet Air filter Air inlet E-4 Outdoor Unit Air Inlet (Rear) Air Outlet Connection Valve Note x If the heat exchanger in the outdoor unit gets dusty, cooling efficiency may fall. So clean the heat exchanger with water when it becomes dirty. However, be careful when you wash the surface of the heat exchanger because it is very sharp. E-5 ENGLISH Wireless Remote Controller-Buttons and Display The wireless remote controller is an optional accessory. To use the wireless remote controller, refer to an appropriate manual. Operating mode Temperature setting Mode selection button Temperature adjustment buttons Filter Reset button Fan speed Air flow direction On Timer setting Off Timer setting Battery discharge indicator Fan speed adjustment button Swing button (Not operated) On Timer button Off Timer button On/Off & Timer Set/Cancel button Note x After cleaning the air filter, press the button. x Duct type air conditioner does not have function of adjusting air flow direction. Therefore, the function is not operated even if you press the button. E-6 The Receiver & Display Unit ENGLISH E-7 The Receiver & Display unit is an optional accessory and it is installed on the wall. To use the receiver & display unit, refer to an appropriate manual. Concealed Type Filter sign indicator Fan indicator Timer indicator Remote control sensor On/Off indicator(Blue) & Removing frost indicator(Red) Standard Type Removing frost indicator Filter sign indicator Remote control sensor On/Off indicator Fan indicator On/Off button Timer indicator Wired Remote Controller-Buttons and Display To use the wired remote controller, refer to an appropriate manual. Operating mode Removing frost indicator Centralized controller indicator (In case of installing the Centralized controller) Communication error indicator On Timer setting Off Timer setting Test indicator Temperature setting Fan speed Air flow direction Filter Sign indicator On/Off button Temperature adjustment buttons On Timer button Timer Set/Cancel button Test button On/Off indicator Fan speed adjustment button Swing button (Not operated) Filter Reset button Mode selection button Note x The button is for your installation specialist. x After cleaning the air filter, press the button. Then the wired remote controller will display the FILTER SIGN indicator when the time to clean the air filter; refer to page 13. x Duct type air conditioner does not have function of adjusting air flow direction. Therefore, the function is not operated even if you press the button. E-8 Centralized Controller ENGLISH E-9 The centralized controller is an optional accessory and it is installed on the wall. To use the centralized controller, refer to an appropriate manual. Front View Operating lamp All On button All Off button On/Off indicators On/Off buttons Index Note x The operating lamp comes on even when only one air conditioner connected to the centralized controller is operating. Side View Operating Mode Switch COOL AUTO HEAT Note x Choose the appropriate operating mode with the Operating Mode Switch that enables the user to choose between the Cool/Auto/Heat mode. Function Controller The function controller is an optional accessory and it is installed on the wall. The function controller is an additional controller which is used with the centralized controller. To use the function controller, refer to an appropriate manual. Operating mode Removing frost indicator Centralized controller indicator Communication error indicator Room number display Temperature setting Fan speed Air flow direction Test indicator Temperature adjustment buttons Indoor unit selection button Filter Sign indicator On/Off & Timer Set/Cancel button On/Off indicator Fan speed adjustment button Swing button Filter Reset button Test button Mode selection button Note x button is for your installation specialist. [. . . ] Water may condense on and drip from the surface of the indoor unit if it is used for a long periods. Low temperature High humidity levels Mode Heating Cooling Drying Outdoor Temperature -15C to 24C approx. 15C to 43C approx. Indoor Temperature 27C or less 21C to 32C approx. [. . . ]