User manual SAMSUNG ML-6100N

[. . . ] Laser Printer User's Guide QwikLaser 6100 Series ELECTRONICS Visit us at: http://www. samsungtelecom. com If you have access to this online service, you can download the User's Guide and drivers from Samsung Electronics. P/N. 1. 00 Copyright This manual is provided for information purposes only. All information included herein is subject to change without notice. Samsung Electronics is not responsible for any damages, direct or indirect, arising from or related to use of this manual. [. . . ] The print material buckles if you load a stack that is too deep or push the stack in too far. Slide the paper width guide to the left until it lightly touches the stack of print material. Do not bend the print material. Print Media Information 3. 9 Closing the MP Tray If you want to close the MP tray, push the extender straight back to collapse the MP tray to its short-length position. Then close the MP tray door. 3. 10 Print Media Information Using Rear Output Tray If you open the rear output tray, the printed paper is placed on the tray with the printed side facing up. If you experience paper jams, especially when you load paper, envelopes, or other special media into the MP tray, use the rear output tray. To use the rear output tray, open the rear cover. The cover functions as an output tray. 2. Pull the extender to extend the output tray to its full-length position to hold longer paper. Print Media Information 3. Printed pages are stacked with print side facing up. Note: The printed pages do not stack on the standard output bin located on top of the printer unless you close the rear output tray. If you want to stack the printed pages on the standard output bin, close the rear output tray. 3. 12 Print Media Information n su mr Sa inte Pr g Memo Print Media Information 3. 13 4 Printing Printing in Windows The following procedure describes the general steps required for printing from various Windows applications. The exact steps for printing a document may vary depending on the application program you are using. Refer to your software application's documentation for the exact printing procedure. Notes: · To use your QwikLaser 6100, you must install a printer driver. The way you access the driver varies depending on the software programs you use. · To use the PostScript driver, you must install the PostScript option, described in Chapter 6: Printer Options. Start the program you are using to create the document, and open the document you want to print. Note: Most Windows applications allow you to make changes to the print settings, such as number of copies, sequence of the pages, paper orientation, and margins. If you go to the File Print Properties dialog box (In Windows 3. 1x, the equivalent command is File Print Setup Options), you'll access the printer driver's Print Setup dialog box, in which you can set other printer properties such as Manual Duplex, Images per Sheet, Booklet Printing, Watermarks or Overlays, available in the PCL6 driver. See the section "Setting Properties" (page 4. 3). [. . . ] 13 Option Cassette You can increase the paper handling capacity of your QwikLaser 6100 by installing the option cassette, which consists of two components, as shown in Figure 6. 1. Figure 6. 1 Support unit Paper tray Review the precautions on page 6. 1 and then follow this procedure to install option cassette in your printer. 1. Turn off the printer and disconnect the power cord. 6. Observe the location of the support unit's connector and tabs. Tab Connector Tab 3. Align the printer with the support unit and lower it into place on the tabs and connector. 4. [. . . ]