User manual SAMSUNG MM-N6

[. . . ] MICRO COMPONENT SYSTEM WITH REMOTE CONTROL MM-N6 Instruction Manual On/Standby Power Surround Open /Close Timer AI Off/Sleep On/Off Timer /Clock Tuner /Band CD Repeat Program /Set Shuffle Mono/ST Classic Rock Pop Aux CD VOL. CD Tuning Mode CD VOL. Safety Warnings GB CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT PRODUCTO LASER CLASE 1 Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION-INVISIBLE LASER RADIATION WHEN OPEN AND INTER LOCKS DEFEATED, AVOID EXPOSURE TO BEAM. This symbol indicates that dangerous voltage which can cause electric shock is present inside this unit. This symbol alerts you to important operating and maintenance instructions accompanying the unit. [. . . ] c Press Program/Set to store the radio station. Result: PROGRAM is no longer displayed and the station is stored. To store any other radio frequencies required, repeat Steps 3 to 8. Selecting a Stored Station You can listen to a stored radio station as follows: GB 7 8 1 2 3 4 Switch the system on by pressing On/Standby. Select the TUNER function by pressing TUNER/Band button. Select the required frequency band by pressing Tuner/Band on the remote control or TUNER/Band again on the front panel. a Press the Tuning Mode button until "PRESET" is displayed. b TUNING and to select the required program. TUNING and until the required frequency is displayed. Another station 9 Press Tuning Mode again to exit the stored station selection function. CD The PROGRAM function can be used to assign a new station to an existing program number. VOL. On/Standby Timer AI Off/Sleep On/Off Timer /Clock Tuner /Band Timer AI Off/Sleep On/Off Power Surround Open /Close 4 CD 1 Tuning Tuning Mode Mode 4 CD CD Repeat Program /Set Timer /Clock Tuner /Band Shuffle Mono/ST 4 VOL. 8 Classic Rock Pop Aux CD 7 CD Repeat Program /Set Shuffle 2 3Mono/ST Improving Radio Reception 6 VOL. You can improve the quality of radio reception by: 8 CD Tuning Mode Rotating the FM or AM(MW) aerial CD 8 VOL. Testing the positions of the FM and AM(MW) aerials before fixing them permanently If reception from a specific FM radio station is poor, press Mono/ST to switch from stereo mode to mono. The quality of the sound will be improved. 6 TUNER On/ Standby Band CD AUX Surround Tuning Mode Classic Rock /Close CD Repeat Repeat (A Power Surround B) 8 8 Pop Timer AI Off/Sleep On/Off Timer /Clock Tuner /Band CD Repeat Program /Set Shuffle Mono/ST Classic Rock Pop Aux 6 VOLUME Phones Open/Close CD Mic VOL 9 Timer Function GB The timer enables you to switch the system on or off at specific times. Example: You wish to wake up to music every morning. If you no longer want the system to be switched on or off automatically, you must cancel the timer. Before setting the timer, check that the current time is correct. For each step, you have a few seconds to set the required options. If you exceed this time, you must start again. On/Standby Power Surround Open /Close 18 Timer AI Off/Sleep On/Off Timer /Clock Tuner /Band CD Repeat Program /Set Shuffle 2Mono/ST 1 2 3 Switch the system on by pressing On/Standby. Press Timer/Clock until TIMER is displayed. Result: ON TIME is displayed (instead of the equalizer symbols) for a few seconds, followed by any switch-on time already set; you can set the timer switch-on time. c Set the minutes by pressing TUNING and . Result: OFF TIME is displayed (instead of the equalizer symbols) for a few seconds, followed by any switch-off time already set; you can now set the timer switch-off time. c Set the minutes by pressing TUNING and . Result: VOL XX is displayed, where XX corresponds to the volume already set. Press TUNING and to adjust the volume level and press Program/Set. Result: The source to be selected is displayed. [. . . ] · The timer has been stopped by pressing Timer On/Off. Press the Power Surround button for 5 seconds in power `OFF'(standby), then it is returned the original position (RESET). · The CD function has not been selected. · The disc has been inserted face down or is either dirty or scratched. [. . . ]