User manual SAMSUNG MM-N7 NO RDS

[. . . ] MICRO COMPONENT SYSTEM WITH REMOTE CONTROL MM-N7 Instruction Manual On/Standby Power Surround Tuner /Band Timer AI Off/Sleep On/Off Timer /Clock Mono/ST CD Repeat Program /Set Shuffle Tape Counter TAPE CD VOL. CD Tuning Mode CD VOL. Safety Warnings GB CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT PRODUCTO LASER CLASE 1 CLASS 1 LASER PRODUCT This Compact Disc player is classified as a CLASS 1 LASER product. Use of controls adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION-INVISIBLE LASER RADIATION WHEN OPEN AND INTER LOCKS DEFEATED, AVOID EXPOSURE TO BEAM. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. [. . . ] a Press the Tuning Mode button until "PRESET" is displayed. b TUNING and to select the required program. TUNING and until the required frequency is displayed. Another station 9 Press Tuning Mode again to exit the stored station selection function. CD The PROGRAM function can be used to assign a new station to an existing program number. VOL. On/Standby Timer AI Off/Sleep On/Off Timer /Clock Power Surround Tuner /Band Mono/ST 4 CD CD Repeat Program /Set Shuffle Tape Counter 7 Timer AI Off/Sleep On/Off 1 23 Timer /Clock Mono/ST Program /Set Tape Counter Tuning Tuning Mode Mode 4 CD 4 VOL. 8 TAPE CD CD Repeat Shuffle Improving Radio Reception 6 VOL. You can improve the quality of radio reception by: 8 CD Tuning Mode Rotating the FM or AM(MW) aerial CD 8 VOL. Testing the positions of the FM and AM(MW) aerials before fixing them permanently If reception from a specific FM radio station is poor, press Mono/ST to switch from stereo mode to mono. The quality of the sound will be improved. 6 TUNER On/ Standby Band CD TAPE AUX CD Repeat Repeat (A B) Tuning Mode CD Synchro REC/Pause Preset EQ 8 8 Power Surround On/Standby Power Surround Tuner /Band Timer AI Off/Sleep On/Off Timer /Clock Mono/ST 6 VOLUME Phones CD Repeat Open/Close Program /Set Shuffle Tape Counter Mic TAPE 9 Listening to a Cassette GB Selecting the Cassette Playback Mode Your micro audio system has three cassette playback modes which enable you to listen to both sides of a cassette automatically. You can select this function during playback or when the cassette is stopped. Press TAPE Mode one or more times to display the required symbol. One side of the cassette and then stops. One side of the cassette The other side of the cassette and then stops Both sides of the cassette indefinitely (both sides are played one after the other until you stop the player). Open/Close 1 2 3 4 5 6 Switch the system on by pressing On/Standby. Select the TAPE function by pressing TAPE on the front panel. Open the cassette deck by pushing on the corner of the cover marked Push Open until you hear a click and then releasing it. Insert the pre-recorded cassette with the open edge of the tape facing downwards. Close the deck by pushing on it until it clicks into place. Side A Side B Result: Press. . . The cassette starts playing. 7 Press any of the following buttons during playback, as required. Listen to the same track again Listen to the next track Listen to the previous track Listen to the track of your choice Press. . . Phones VOLUME Mic once once twice or the appropriate number of times Result: The number of tracks remaining is displayed and changes as you move forward or backward through the tracks. If there are very quiet passages on a track, the automatic search function may stop before the end of the track. Also, a very short silence between two tracks may not be detected. Press. . . Tape Counter When playing a cassette, a counter is displayed to enable you to take note of the counter value at the start of each track and thus start playback at the beginning of the track to which you wish to listen. The counter is only displayed when a cassette is being played. Before starting to record a cassette for which you wish to take note of the counter values at the beginning of each track, reset the counter by pressing Tape Counter. Program /Set Tape Counter 8 To. . . + or ­ (or the VOLUME + or ­ buttons on the front panel) Stop the playback or search STOP ( ) When the cassette is stopped, select one of the following functions as required. Rewind the cassette Fast-forward the cassette The cassette player stops automatically when the beginning or end of the cassette is reached. Press. . . CD Repeat Shuffle TAPE Maintaining the Sound Quality To obtain the best possible results from your cassette player, you must clean it regularly (heads, roller and drive capstan). 35 26 TUNER On/ Standby Band CD TAPE AUX CD Repeat 1 Repeat (A B) Tuning Mode CD Synchro REC/Pause Preset EQ TUNER On/ Standby Band 8 Power Surround CD TAPE AUX CD Repeat Repeat (A B) Tuning Mode CD Synchro REC/Pause Preset EQ Power Surround CD Re eat /Set Shuffle Counter VOL. VOL. Open the deck by pressing the Push Open button. [. . . ] · The cassette has not been inserted correctly. · The cassette player has not been closed. · The tape is either slack or broken. · The rollers or drive capstans are dirty. [. . . ]