User manual SAMSUNG N760

[. . . ] Notices No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, mechanical photocopying, recording or otherwise, without the prior written permission of the manufacturer. The information within this manual is subject to change without notice. The manufacturer shall not be held liable for technical or editorial errors or omissions contained in herein; nor for incidental or consequential damages resulting from the furnishing, performance or use of this material. Microsoft, Windows is a registered trademark of the Microsoft Corporation. [. . . ] Ensure the correct orientation so that the battery fits in its slot properly. 1. With the computer's power off, close the LCD panel and turn the computer over so the bottom of the unit faces up. Slide the battery into the battery pack into the compartment (Figure 40). Ensure the battery is fully inserted into the compartment. Using the Battery 49 3. Slide the battery pack latches toward the center of the computer. Make sure the locking battery latch is in the lock position. Locking Battery Latch Figure 40. Installing the Battery Monitoring the Battery Charge Battery life is affected by factors such as the power-management settings in System Setup, the applications you use, and the brightness settings of the LCD. Under normal usage, the battery charge lasts approximately 3 hours for standard battery (undocked), 1 1/2 on standard battery (docked) and approximately 5 hours for the long life battery (undocked). Battery life estimates are subject to variation. The actual life of your battery may be less than the estimates given in the manual. 50 Users Manual Power Meter The Power Meter displays the charge of the batteries and the current source of computer power, AC or batteries. You may monitor the battery charge or usage by using the "Power Meter". To access the power meter click icon on the task bar or click Start > Control Panel > Power Options > Power Meter tab. Figure 41. Power Meter You may also check battery charge by moving the cursor to the box will display the % of charge. icon, a small dialog Battery Warnings If the battery charge is low (about 10%) you have approximately 5­10 minutes of battery life left. You should: · Save your work and. · Connect the power cord the computer or turn off the computer and install a fully charged battery. You can adjust the battery alarm features by using the operating systems power management program (Control Panel > Power management in Windows Me). If you cannot run your computer from the battery and the battery will not charge when you attach the power cord, the problem may be that: · The battery temperature is below 50° F (10° C) or over 90° F (32° C). If you think the battery temperature is too hot or too cold, turn off the computer, remove the battery, and let the battery reach room temperature. Replace the battery with a new battery. Using the Battery 51 Using System Setup The System Setup program enables you to configure your computer hardware and set security and power-savings options. The settings you choose are stored in batterymaintained CMOS memory that saves the information even when the computer's power is turned off. When your computer is turned back on, it is configured with the values found in this memory. Run System Setup if you get a message prompting you to run the program. You may also want to run System Setup, particularly the first time you use your computer, to set the time and date, use security or power-management features, or alter the settings of other features. Your computer's version of System Setup may not include all the fields listed here or may include additional fields. [. . . ] The pixels are so close together that they look as though they are connected. An LCD screen displays thousands or millions of pixels. Plug and Play A plug and play operating system automatically configures computer components to work with your system. With this type of operating system, you normally do not need to set jumpers on devices or set memory addresses or IRQs. [. . . ]