User manual SAMSUNG NL20J7100WB/UR

[. . . ] 9 What should I do if the warming drawer doesn't work?We ask you to read the instructions in this booklet very carefully as this will allow you to get the best results from using your warming drawer. Before connecting the appliance compare the power data (voltage and frequency) indicated on the characteristics plate with those of the power supply in question. If these data do not match there may be problems. [. . . ] Before using the warming drawer for the first time, remove this film carefully. Make sure that the warming drawer is not damaged in any way. check that the drawer opens and closes correctly. If you find any damage, contact the Technical Assistance Service. Attention: the power socket should be easily accessible after the warming drawer has been installed. The warming drawer should only be built-in in combination with those appliances indicated by the manufacturer. If it is fitted in combination with other appliances, the guarantee is no longer valid since it is impossible to guarantee that the warming drawer will work correctly. installation To build-in the warming drawer in combination with another appliance there must be a fixed, interim shelf in the housing unit to support the weight of both appliances. The appliance to be combined with the warming drawer will be placed directly on the latter without any need to have a separating shelf. To build-in the appliance which is combined with the warming drawer, follow the instructions set out in the respective instructions and fitting booklet. The relevant installation dimensions are indicated in mm in the diagrams shown at the end of this booklet. Place the warming drawer on the shelf and slide it towards the interior of the niche in such a way that it is centred and completely lined up with the front of the unit. Check that the warming drawer frame is properly levelled and is sitting evenly on the shelf. Open the drawer and fix the warming drawer to the sides of the unit using the two screws provided. electrical Connection The warming drawer is equipped with a power cable and plug for single phase current. We advise that the plug is connected to a socket that is easily accessible after installation. If the warming drawer is to be installed on a permanent basis it should be installed by a qualified technician. In such a case, the appliance should be connected to a circuit with an all-pole circuit breaker with a minimum separation of 3 mm between contacts. The data necessary for the electrical connection are described on the warming drawer characteristics plate and these must be compatible with those of the power outlet you are going to use. wARNING: THE WARMING DRAWER MUST BE CONNECTED TO EARTH. The manufacturer and retailers do not accept responsibility for any damage that may be caused to people, animals or property if these installation instructions are not observed. How the warming drawer works This appliance is equipped with a warm air circulation system. [. . . ] The warming drawer can be loaded with a maximum of 25 kg. Below we give you some crockery arrangements as examples: Or one of the following 20 dinner plates Ø 28 cm 36 soup bowls Ø 22 cm 30 soup bowls Ø 10cm 10 dinner plates Ø 28cm 10 soup bowls Ø 22 cm 10 pizza plates Ø 36 cm 80 expresso cups 40 cappuccino cups 30 glasses 18 soup bowls Ø 22 cm; 2 soup tureens 21 cm x 18 cm Etc. Cleaning is the only maintenance action that is required normally. Cleaning must be done with the warming drawer disconnected from the electrical power supply. [. . . ]