User manual SAMSUNG P1253S

[. . . ] Make sure that water and electrical connections are made by qualified technicians, observing the manufacturer's instructions (see "Installing the Washing Machine" on page 3) and local safety regulations. All packaging and shipping bolts must be removed before the appliance is used. Serious damage may occur if they are not removed. See "Removing the shipping bolts" on page 4. [. . . ] Delay Start selection button Press this button repeatedly to rotate between the retarded start options available. (from 1 hour to 24hour, in 1 hour increments) Start/Pause button Press to pause and restart programs. (On/Off) button Press once to turn the washing machine on, press again to turn the washing machine off. If the washing machine power is left on for longer than 10 minutes without any buttons being touched, the power automatically turns off. - If you press the "Child Lock" button(Spin+Option button) longer than 2 sec during operation, this function is selected. q What is the "Child Lock" function?- If once this function is selected, no change can be done until the end of laundry. - Press the "Child Lock" button(Spin+Option button) longer than 2 sec to cancel the function. 5 Washing a Load of Laundry WM stops the current step of the cycle or does not proceed to the next step of washing (indication of remain time on LED display may increase). Your new washing machine is equipped with Fuzzy Logic system, which not only sets the optimum level of water and other parameters of washing, but also controls the washing process as well as makes necessary corrections in order to provide better washing results. In the above- mentioned matter, the Fuzzy Logic system has detected deviations in washing cycle such as: high quantity of detergent at the end of the cycle, high vibration level while spinning, etc. You can adjust existing wash programs, i. e. After detection of such abnormalities, the washing machine is suspending the normal course of program in order to normalize these parameters and continue the cycle. Fuzzy logic system makes 7 attempts to eliminate such deviations. If it is impossible to normalize the above mentioned deviations by Fuzzy Logic system, you will see the corresponding indication on LED lamps. Press the Option button until the "Prewash" indicator lights up on the control panel. Rinse+ Your machine will run through an additional rinsing cycle. The washing duration will be prolonged accordingly. Rinse Hold The laundry remains soaking in the final rinse water. Reconnect the water supply hose to the water faucet and check if the water supply and drain operations are normal. Cleaning the exterior 1. Wipe the washing machine surfaces, including the control panel, with a soft cloth and non-abrasive household detergents. Do not pour water on the washing machine. Cleaning the debris filter Clean the debris filter 2 or 3 times a year. Remove the base cover from the front of the washing machine. Wash any dirt or other material from the filter. Make sure the drain pump propeller behind the filter is not blocked. Replace the base cover. Cleaning the water hose mesh filter You should clean the water hose mesh filter at least one time per year, , or when the lamps on your machine flickers: To do this: 1. [. . . ] (Make sure the holder of drain hose in the back is intact) Check the end of the drain hose is submerged in water. · L · Before contacting After-Sales service: 1. Try to remedy the problem (See "Troubleshooting" on this page). Restart the programme to see if the fault is repeated. If the malfunction persists, call after-sales service and describe the problem. [. . . ]