User manual SAMSUNG PL42A450

[. . . ] Connect a Component Cable(Not supplied) between the COMPONENT IN (1 or 2) [Y, PB, PR] jacks on the TV and the COMPONENT jacks on the Cable Box/Satellite receiver (Set-Top Box). AUDIO OUT jacks on the Cable Box/Satellite receiver (Set-Top Box). 2. Connect Audio Cables(Not supplied) between the COMPONENT IN (1 or 2) [R-AUDIO-L] jacks on the TV and the Storing Channels in Memory (Automatic Method) 1 2 Press the MENU button to display the menu. Press the or button to select Channel, then press the ENTER button. [. . . ] Press the or button to select Auto Program, then press the ENTER button. Press the or button to select the antenna connection, then press the ENTER button. TV Channel Antenna : Air Auto Program Clear Scrambled Channel Channel List Name Fine Tune Signal Strength Move Enter Return 4 Air : Air antenna signal. Auto : Air and Cable antenna signals. When selecting the Cable TV system: Press the ENTER button to start the auto program. Press the or to select the correct analog signal cable system source from among STD, HRC, and IRC, then press the ENTER button. If you have Digital cable TV, select the cable system signal source for both Analog and Digital. 5 STD, HRC, and IRC identify various types of cable TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area. At this point the signal source has been selected. The TV begins memorizing all available stations. After all the available channels are stored, the TV starts to remove scrambled channels (see page 36 of the owner's manual). The Auto program menu then reappears. If you want to stop Auto Programming, press the ENTER button. Press the EXIT button to exit. The Stop Auto Program?· All available analog channels are automatically stored in memory. · It takes approximately 3 to 10 minutes to memorize channels. 2 Troubleshooting If the TV seems to have a problem, first try this list of possible problems and solutions. On your equipment check (STB, DVD, etc) ; Power and Signal Cable. The TV is using its power management system. Press the Source button on the panel or remote control. Although the TV caption shows HD, The HD(High Definition) caption that appears when switching channels or when pressing the visual quality is not satisfactory. the INFO button on the remote control means the selected channel is a digital channel. If the broadcasting station converts an analog signal into digital and transmits the signal, the visual quality may not be perfect. A distorted picture appears in the If Just Scan is selected in some external devices, a distorted picture appears in the corner corner of the screen. picture may appear in the corner of the screen. This symptom is caused by external devices, not the TV. [. . . ] picture may appear in the corner of the screen. This symptom is caused by external devices, not the TV. This is caused by minor systems operation and is not a defect. The "Resets all settings to the default This appears when you press and hold the EXIT button for a while. [. . . ]