User manual SAMSUNG PL42B450B1

[. . . ] Connect an HDMI Cable(Not supplied) between the HDMI IN (1, 2(DVI) or 3) jack on the TV and the HDMI jack on the Cable Box/Satellite receiver (Set-Top Box). No additional Audio connection is needed for an HDMI to HDMI connection. When using an HDMI/DVI cable connection, you must use the HDMI IN 2(DVI) jack. 1 (450SA)-01924A_CMS-0909. indd 1 2009-09-10 11:38:27 CONNECTING A CABLE BOX/SATELLITE RECEIVER (SET-TOP BOX) VIA DVI DVD Player or Cable Box / Satellite receiver (Set-Top Box) TV REAR PANEL Audio Cable (Not supplied) 2 1 HDMI/DVI Cable (Not supplied) 1. Connect an HDMI Cable(Not supplied) between the HDMI IN 2(DVI) jack on the TV and the HDMI jack on the Cable Box/Satellite receiver (Set-Top Box). 2. [. . . ] Connect a Component Cable(Not supplied) between the COMPONENT IN 1, 2 [Y, PB, PR] jacks on the TV and the COMPONENT jacks on the Cable Box/Satellite receiver (Set-Top Box). 2. Connect Audio Cables(Not supplied) between the COMPONENT IN 1, 2 [R-AUDIO-L] jacks on the TV and the AUDIO OUT jacks on the Cable Box/Satellite receiver (Set-Top Box). 2 (450SA)-01924A_CMS-0909. indd 2 2009-09-10 11:38:29 Troubleshooting If the TV seems to have a problem, first try this list of possible problems and solutions. If none of these troubleshooting tips apply, call Samsung customer service at 1-800-SAMSUNG. First, check the volume of units connected to your TV (digital broadcasting receiver, DVD, cable broadcasting receiver, VCR, etc. ). Unplug the TV for 30 seconds, then try operating it again. Clean the upper edge of the remote control (transmission window). Press the TV button to put your remote control in the TV mode. Check that the "+" and "-" ends of the batteries are inserted correctly. The HD(High Definition) caption that appears when switching channels or when pressing the Information button on the remote control means the selected channel is a digital channel. If the broadcasting station converts an analog signal into digital and transmits the signal, the visual quality may not be perfect. If Screen Fit is selected in some external devices, a distorted picture may appear in the corner of the screen. This symptom is caused by external devices, not the TV. This is caused by minor systems operation and is not a defect. There may be few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product. This appears when you press and hold the EXIT button for a while. [. . . ] This appears when you press and hold the EXIT button for a while. The product settings are reset to the factory defaults. 3 Poor sound quality. No picture or sound. No sound or sound is too low at maximum volume. [. . . ]